Three-quarter view of a stainless pass box door hinge with eight countersunk holes

Temiz Oda Ekipmanları Yedek Parçaları

Pass Box Kapı Mentezi

A robust stainless-steel butt hinge that supports repeated pass box door movement while maintaining stable panel alignment.

Satin Stainless Construction
Eight-Point Mounting
Full-Length Hinge Pin
Stable Door Alignment

Alıntı isteği Browse ürünleri

Ürün tanıtımı

The pass box door hinge connects the transfer-chamber door leaf to its frame and carries repeated opening loads without introducing excessive play. Two machined stainless leaves, eight countersunk fixing points and a continuous pin distribute load along the joint. The satin surface is suitable for routine wipe-down, while the compact butt-hinge geometry fits flush chamber construction. Replacement selection should match leaf dimensions, hole centers, pin axis, door weight, opening angle and the existing frame reinforcement.

Ana Özellikler

Two rigid leaves distribute door load across the reinforced frame and panel.

Eight countersunk holes allow flush fastener seating without protruding heads.

A continuous pin maintains a consistent pivot axis through repeated operating cycles.

Satin stainless surfaces resist routine cleaning exposure and match pass box interiors.

Müşteri Ürün Sorunları

A replacement hinge must match the existing pivot line and fixing pattern to prevent sagging, rubbing or loss of gasket compression.

A shifted pivot axis causes the door edge to rub the frame.Leaf width, barrel offset and mounting position are matched to the original hinge centerline.

Insufficient fixing support allows the hinge screws to loosen under door weight.Eight countersunk locations spread the load into suitable frame and door reinforcement.

Pin wear creates door play and inconsistent gasket compression.A close-fitting full-length stainless pin provides a stable bearing axis and replaceable service point.

Rough or corroded hardware is difficult to clean in the transfer area.Smooth satin stainless leaves and barrel provide a durable wipe-clean exposed finish.

Tipik uygulamalar

Static pass box doorsDynamic pass-through chamber doorsMaterial transfer hatch repairsStainless cleanroom cabinet doors

Teknik parametreler

Typical material and dimensional ranges for stainless pass box butt hinges are shown below.

Temel malzemeler	Austenitic stainless-steel leaves, barrel and hinge pin
Panel kalınlığı	3-6 mm nominal hinge-leaf thickness
Effective Width (Etkili Genişlik)	80-160 mm overall open hinge width
Maksimum uzunluk	Up to 240 mm hinge height
Çelik yüz yüze kalınlığı	3-6 mm stainless-steel leaf thickness
Core Density (Çekirdek Yoğunluğu)	7900-8000 kg/m³ for stainless-steel components
Termal İletkenlik	14-16 W/(m·K) for austenitic stainless steel
Yüzey bitirme	Fine satin brushed stainless steel with deburred edges
Ortak tip	Two-leaf butt hinge with central knuckle barrel, continuous pin and countersunk fixing holes
Customization (Özelleşme)	Kullanılan uygulama ve çalışma ortamına göre kullanılabilir.

Mevcut Seçenekler

Alternative leaf width and heightCustom countersunk hole centersRemovable or retained pinPolished or satin surface finish

Planning a Pass Box Door Hinge specification?

Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.

Ekibimizle konuşun