Three-quarter view of a stainless pass box door hinge with eight countersunk holes

Запчасти для оборудования для чистых помещений

Паспорт коробки дверной шарниры

A robust stainless-steel butt hinge that supports repeated pass box door movement while maintaining stable panel alignment.

Satin Stainless Construction
Eight-Point Mounting
Full-Length Hinge Pin
Stable Door Alignment

Запрос котировки Просмотреть продукты

Введение продукции

The pass box door hinge connects the transfer-chamber door leaf to its frame and carries repeated opening loads without introducing excessive play. Two machined stainless leaves, eight countersunk fixing points and a continuous pin distribute load along the joint. The satin surface is suitable for routine wipe-down, while the compact butt-hinge geometry fits flush chamber construction. Replacement selection should match leaf dimensions, hole centers, pin axis, door weight, opening angle and the existing frame reinforcement.

Основные характеристики

Two rigid leaves distribute door load across the reinforced frame and panel.

Eight countersunk holes allow flush fastener seating without protruding heads.

A continuous pin maintains a consistent pivot axis through repeated operating cycles.

Satin stainless surfaces resist routine cleaning exposure and match pass box interiors.

Обеспокоенность клиентов продуктами

A replacement hinge must match the existing pivot line and fixing pattern to prevent sagging, rubbing or loss of gasket compression.

A shifted pivot axis causes the door edge to rub the frame.Leaf width, barrel offset and mounting position are matched to the original hinge centerline.

Insufficient fixing support allows the hinge screws to loosen under door weight.Eight countersunk locations spread the load into suitable frame and door reinforcement.

Pin wear creates door play and inconsistent gasket compression.A close-fitting full-length stainless pin provides a stable bearing axis and replaceable service point.

Rough or corroded hardware is difficult to clean in the transfer area.Smooth satin stainless leaves and barrel provide a durable wipe-clean exposed finish.

Типичные приложения

Static pass box doorsDynamic pass-through chamber doorsMaterial transfer hatch repairsStainless cleanroom cabinet doors

Технические параметры

Typical material and dimensional ranges for stainless pass box butt hinges are shown below.

Основной материал	Austenitic stainless-steel leaves, barrel and hinge pin
Толщина панели	3-6 mm nominal hinge-leaf thickness
эффективная ширина	80-160 mm overall open hinge width
Максимальная длина	Up to 240 mm hinge height
Толщина линий стали	3-6 mm stainless-steel leaf thickness
Плотность ядра	7900-8000 kg/m³ for stainless-steel components
Теплопроводимость	14-16 W/(m·K) for austenitic stainless steel
Поверхностная отделка	Fine satin brushed stainless steel with deburred edges
Объединенный тип	Two-leaf butt hinge with central knuckle barrel, continuous pin and countersunk fixing holes
Customization	Доступно в зависимости от предполагаемого применения и операционной среды.

Доступные варианты

Alternative leaf width and heightCustom countersunk hole centersRemovable or retained pinPolished or satin surface finish

Planning a Pass Box Door Hinge specification?

Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.

Поговорите с нашей командой