Englisch
DeutschCurrent
Arabisch
Französisch
indonesisch
Japanisch
Koreanisch
Malaiisch
Portugiesisch
Russisch
Spanisch
Thailändisch
Türkischer Sprache
Vietnamesisch
Cleanroom Equipment Ersatzteile
Pass Box Tür Scharnier
A robust stainless-steel butt hinge that supports repeated pass box door movement while maintaining stable panel alignment.
- Satin Stainless Construction
- Eight-Point Mounting
- Full-Length Hinge Pin
- Stable Door Alignment
Produkteinführung
The pass box door hinge connects the transfer-chamber door leaf to its frame and carries repeated opening loads without introducing excessive play. Two machined stainless leaves, eight countersunk fixing points and a continuous pin distribute load along the joint. The satin surface is suitable for routine wipe-down, while the compact butt-hinge geometry fits flush chamber construction. Replacement selection should match leaf dimensions, hole centers, pin axis, door weight, opening angle and the existing frame reinforcement.
Key Features
Eight countersunk holes allow flush fastener seating without protruding heads.
A continuous pin maintains a consistent pivot axis through repeated operating cycles.
Satin stainless surfaces resist routine cleaning exposure and match pass box interiors.
Kunden Produktbedenken
A replacement hinge must match the existing pivot line and fixing pattern to prevent sagging, rubbing or loss of gasket compression.
A shifted pivot axis causes the door edge to rub the frame.Leaf width, barrel offset and mounting position are matched to the original hinge centerline.
Insufficient fixing support allows the hinge screws to loosen under door weight.Eight countersunk locations spread the load into suitable frame and door reinforcement.
Pin wear creates door play and inconsistent gasket compression.A close-fitting full-length stainless pin provides a stable bearing axis and replaceable service point.
Rough or corroded hardware is difficult to clean in the transfer area.Smooth satin stainless leaves and barrel provide a durable wipe-clean exposed finish.
Typische Anwendungen
Static pass box doorsDynamische Pass-Through - KammertürenMaterial transfer hatch repairsStainless cleanroom cabinet doors
Technische Parameter
Typical material and dimensional ranges for stainless pass box butt hinges are shown below.
| Core Material | Austenitic stainless-steel leaves, barrel and hinge pin |
|---|---|
| Panel Dicke | 3-6 mm nominal hinge-leaf thickness |
| Effektive Breite | 80-160 mm overall open hinge width |
| Maximale Länge | Up to 240 mm hinge height |
| Stahl facing Dicke | 3-6 mm stainless-steel leaf thickness |
| Kerndichte | 7900-8000 kg/m³ for stainless-steel components |
| Thermische Leitfähigkeit | 14 - 16 W / (m · K) für austenitischen Edelstahl |
| Oberfläche Finish | Fine satin brushed stainless steel with deburred edges |
| Gemeinsamer Typ | Two-leaf butt hinge with central knuckle barrel, continuous pin and countersunk fixing holes |
| Customisierung | Verfügbar je nach beabsichtigter Anwendung und Betriebsumgebung. |
Verfügbare Optionen
Alternative leaf width and heightCustom countersunk hole centersRemovable or retained pinPolished or satin surface finish
Planning a Pass Box Door Hinge specification?
Senden Sie uns Ihre Abmessungen, Installationsbedingungen, Leistungsziele und gewünschte Oberflächenveredelung.
