Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Accesorios de instalación de sala limpia
Firestop Sealant por
A flexible firestop joint compound for closing smoke paths at cleanroom construction joints and compatible penetration-system interfaces.
- Smoke-Tight Joint Closure
- Movement-Capable Seal
- Low-Shrink Application
- System-Compatible Detailing
Introducción del producto
Firestop sealant is a cartridge-applied compound used as the exposed seal component in tested wall, floor and service-penetration arrangements. The non-sag paste is tooled over the specified backing material to create a continuous smoke-resistant joint while retaining the movement capability needed at modular panel and building interfaces. Selection is based on the complete supporting construction, opening geometry and service conditions rather than on sealant alone.
Características clave
Elastic grades accommodate cyclic movement at perimeter and construction joints.
Low-shrink curing helps preserve contact with prepared joint flanks.
Red or contrasting compounds make installed coverage easier to inspect before enclosure.
Preocupaciones del producto del cliente
A fire-resisting cleanroom interface must close smoke paths while remaining compatible with the complete wall, backing and penetration arrangement.
Sealant selected independently of the supporting assembly may not suit the opening geometry.Joint width, depth, backing, substrates and services are matched as one defined firestop system.
Building movement can split a rigid perimeter seal and create a smoke path.A movement-capable grade and correct width-to-depth profile allow controlled elastic deformation.
Dust or weak coatings cause adhesion loss along joint flanks.Sound substrates are cleaned and, where required, primed before backing and sealant placement.
Inconsistent bead depth leaves thin sections around penetrations.Specified backing material controls depth and supports uniform tooling around the full opening.
Aplicaciones típicas
Cleanroom wall-to-slab jointsFire-rated partition perimetersService-penetration annular sealsCable and pipe opening systemsSmoke-control construction joints
Parámetros técnicos
Typical construction and application ranges for an elastic cartridge-applied firestop joint sealant are listed below.
| Materiales Core | One-component acrylic, silicone or hybrid firestop elastomer |
|---|---|
| Panel de espesor | 6-25 mm typical installed seal depth |
| Ancho efectivo | 6-50 mm practical construction-joint width |
| Longitud máxima | Up to 10000 mm continuous prepared joint section |
| Acero frente a espesor | 0.50-1.50 mm compatible coated-steel panel facing |
| Densidad Core | Approximately 1300-1700 kg/m³ uncured compound density |
| Conductividad térmica | Approximately 0.20-0.50 W/(m·K) for cured sealant |
| Superficie acabada | Smooth tooled red, white or gray elastomeric surface |
| Tipo conjunto | Backed perimeter, construction or penetration annular joint within a compatible firestop assembly |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
Red, white or gray compoundAcrylic or silicone chemistryCartridge or foil-pack supplyCompatible mineral-wool or backing system
Planning a Firestop Sealant specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
