Three-quarter view of a red firestop sealant cartridge with separate application nozzle

Aksesoris Instalasi Cleanroom

Firestop Sealant (Sealer)

A flexible firestop joint compound for closing smoke paths at cleanroom construction joints and compatible penetration-system interfaces.

Smoke-Tight Joint Closure
Movement-Capable Seal
Low-Shrink Application
System-Compatible Detailing

Permintaan untuk kutipan Browse Produk

Perkenalan produk

Firestop sealant is a cartridge-applied compound used as the exposed seal component in tested wall, floor and service-penetration arrangements. The non-sag paste is tooled over the specified backing material to create a continuous smoke-resistant joint while retaining the movement capability needed at modular panel and building interfaces. Selection is based on the complete supporting construction, opening geometry and service conditions rather than on sealant alone.

Fitur utama:

Non-sag consistency supports controlled installation in vertical and overhead joint openings.

Elastic grades accommodate cyclic movement at perimeter and construction joints.

Low-shrink curing helps preserve contact with prepared joint flanks.

Red or contrasting compounds make installed coverage easier to inspect before enclosure.

Kekhawatiran produk pelanggan

A fire-resisting cleanroom interface must close smoke paths while remaining compatible with the complete wall, backing and penetration arrangement.

Sealant selected independently of the supporting assembly may not suit the opening geometry.Joint width, depth, backing, substrates and services are matched as one defined firestop system.

Building movement can split a rigid perimeter seal and create a smoke path.A movement-capable grade and correct width-to-depth profile allow controlled elastic deformation.

Dust or weak coatings cause adhesion loss along joint flanks.Sound substrates are cleaned and, where required, primed before backing and sealant placement.

Inconsistent bead depth leaves thin sections around penetrations.Specified backing material controls depth and supports uniform tooling around the full opening.

Aplikasi yang Tipis

Cleanroom wall-to-slab jointsFire-rated partition perimetersService-penetration annular sealsCable and pipe opening systemsSmoke-control construction joints

Parameter teknis

Typical construction and application ranges for an elastic cartridge-applied firestop joint sealant are listed below.

Bahan inti	One-component acrylic, silicone or hybrid firestop elastomer
Ketebalan Panel (Panel Thickness)	6-25 mm typical installed seal depth
Efektif lebar	6-50 mm practical construction-joint width
Panjang maksimum	Up to 10000 mm continuous prepared joint section
Baja menghadap ketebalan	0.50-1.50 mm compatible coated-steel panel facing
Kepadatan inti (core density)	Approximately 1300-1700 kg/m³ uncured compound density
Konduktivitas Termal (Thermal Conductivity)	Approximately 0.20-0.50 W/(m·K) for cured sealant
Permukaan selesai	Smooth tooled red, white or gray elastomeric surface
Jenis Bersama	Backed perimeter, construction or penetration annular joint within a compatible firestop assembly
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Red, white or gray compoundAcrylic or silicone chemistryCartridge or foil-pack supplyCompatible mineral-wool or backing system

Planning a Firestop Sealant specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami