Englisch
DeutschCurrent
Arabisch
Französisch
indonesisch
Japanisch
Koreanisch
Malaiisch
Portugiesisch
Russisch
Spanisch
Thailändisch
Türkischer Sprache
Vietnamesisch
Cleanroom Installation Zubehör
Firestop Sealant
A flexible firestop joint compound for closing smoke paths at cleanroom construction joints and compatible penetration-system interfaces.
- Smoke-Tight Joint Closure
- Movement-Capable Seal
- Low-Shrink Application
- System-Compatible Detailing
Produkteinführung
Firestop sealant is a cartridge-applied compound used as the exposed seal component in tested wall, floor and service-penetration arrangements. The non-sag paste is tooled over the specified backing material to create a continuous smoke-resistant joint while retaining the movement capability needed at modular panel and building interfaces. Selection is based on the complete supporting construction, opening geometry and service conditions rather than on sealant alone.
Key Features
Elastic grades accommodate cyclic movement at perimeter and construction joints.
Low-shrink curing helps preserve contact with prepared joint flanks.
Red or contrasting compounds make installed coverage easier to inspect before enclosure.
Kunden Produktbedenken
A fire-resisting cleanroom interface must close smoke paths while remaining compatible with the complete wall, backing and penetration arrangement.
Sealant selected independently of the supporting assembly may not suit the opening geometry.Joint width, depth, backing, substrates and services are matched as one defined firestop system.
Building movement can split a rigid perimeter seal and create a smoke path.A movement-capable grade and correct width-to-depth profile allow controlled elastic deformation.
Dust or weak coatings cause adhesion loss along joint flanks.Sound substrates are cleaned and, where required, primed before backing and sealant placement.
Inconsistent bead depth leaves thin sections around penetrations.Specified backing material controls depth and supports uniform tooling around the full opening.
Typische Anwendungen
Cleanroom wall-to-slab jointsFire-rated partition perimetersService-penetration annular sealsCable and pipe opening systemsSmoke-control construction joints
Technische Parameter
Typical construction and application ranges for an elastic cartridge-applied firestop joint sealant are listed below.
| Core Material | One-component acrylic, silicone or hybrid firestop elastomer |
|---|---|
| Panel Dicke | 6-25 mm typical installed seal depth |
| Effektive Breite | 6-50 mm practical construction-joint width |
| Maximale Länge | Up to 10000 mm continuous prepared joint section |
| Stahl facing Dicke | 0.50-1.50 mm compatible coated-steel panel facing |
| Kerndichte | Approximately 1300-1700 kg/m³ uncured compound density |
| Thermische Leitfähigkeit | Approximately 0.20-0.50 W/(m·K) for cured sealant |
| Oberfläche Finish | Smooth tooled red, white or gray elastomeric surface |
| Gemeinsamer Typ | Backed perimeter, construction or penetration annular joint within a compatible firestop assembly |
| Customisierung | Verfügbar je nach beabsichtigter Anwendung und Betriebsumgebung. |
Verfügbare Optionen
Red, white or gray compoundAcrylic or silicone chemistryCartridge or foil-pack supplyCompatible mineral-wool or backing system
Planning a Firestop Sealant specification?
Senden Sie uns Ihre Abmessungen, Installationsbedingungen, Leistungsziele und gewünschte Oberflächenveredelung.
