Three-quarter view of a red firestop sealant cartridge with separate application nozzle

クリーンルームの設置付属品

ファイアストップシーラント

A flexible firestop joint compound for closing smoke paths at cleanroom construction joints and compatible penetration-system interfaces.

Smoke-Tight Joint Closure
Movement-Capable Seal
Low-Shrink Application
System-Compatible Detailing

見積もりリクエスト製品案内

商品紹介

Firestop sealant is a cartridge-applied compound used as the exposed seal component in tested wall, floor and service-penetration arrangements. The non-sag paste is tooled over the specified backing material to create a continuous smoke-resistant joint while retaining the movement capability needed at modular panel and building interfaces. Selection is based on the complete supporting construction, opening geometry and service conditions rather than on sealant alone.

主要な特徴

Non-sag consistency supports controlled installation in vertical and overhead joint openings.

Elastic grades accommodate cyclic movement at perimeter and construction joints.

Low-shrink curing helps preserve contact with prepared joint flanks.

Red or contrasting compounds make installed coverage easier to inspect before enclosure.

お客様の製品に関する懸念事項

A fire-resisting cleanroom interface must close smoke paths while remaining compatible with the complete wall, backing and penetration arrangement.

Sealant selected independently of the supporting assembly may not suit the opening geometry.Joint width, depth, backing, substrates and services are matched as one defined firestop system.

Building movement can split a rigid perimeter seal and create a smoke path.A movement-capable grade and correct width-to-depth profile allow controlled elastic deformation.

Dust or weak coatings cause adhesion loss along joint flanks.Sound substrates are cleaned and, where required, primed before backing and sealant placement.

Inconsistent bead depth leaves thin sections around penetrations.Specified backing material controls depth and supports uniform tooling around the full opening.

典型的な用途

Cleanroom wall-to-slab jointsFire-rated partition perimetersService-penetration annular sealsCable and pipe opening systemsSmoke-control construction joints

技術的なパラメータ

Typical construction and application ranges for an elastic cartridge-applied firestop joint sealant are listed below.

コア材料	One-component acrylic, silicone or hybrid firestop elastomer
パネルの厚さ	6-25 mm typical installed seal depth
有効幅	6-50 mm practical construction-joint width
最大長さ	Up to 10000 mm continuous prepared joint section
鋼鉄の厚さを直面する	0.50-1.50 mm compatible coated-steel panel facing
コア密度	Approximately 1300-1700 kg/m³ uncured compound density
熱伝導率	Approximately 0.20-0.50 W/(m·K) for cured sealant
表面仕上げ	Smooth tooled red, white or gray elastomeric surface
ジョイントタイプ	Backed perimeter, construction or penetration annular joint within a compatible firestop assembly
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Red, white or gray compoundAcrylic or silicone chemistryCartridge or foil-pack supplyCompatible mineral-wool or backing system

Planning a Firestop Sealant specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する