Surface-mounted cleanroom LED luminaire with complete sealed white body

Освещение и электрическое оборудование в чистых помещениях

Поверхностный свет чистой комнаты

A fully enclosed ceiling light that mounts below a solid cleanroom panel where recessed installation is unavailable.

No Ceiling Recess Required
Hole-Free Smooth Housing
Gasketed Lens Frame
Vapor-Tight Cable Entry

Введение продукции

The surface-mounted fixture fixes directly to a sealed ceiling plate and encloses its driver, wiring and optical chamber in one shallow rectangular body. Radiused housing edges, concealed mounting points and a smooth lens face allow the exterior to be wiped without reaching into a ceiling opening. A gasketed access plate accepts sealed conduit or cable glands from above or at the end of the housing.

Основные характеристики

A closed back plate installs against solid panels without a large ceiling cutout.

Radiused exposed edges support continuous wiping around the fixture.

The perimeter gasket compresses evenly under retained frame fasteners.

A sealed entry plate organizes incoming power without an open knockout.

A broad opal lens limits harsh luminance beneath low ceilings.

Обеспокоенность клиентов продуктами

Surface fixtures are easy to retrofit but can introduce ledges, exposed fasteners and unsealed wiring entries if not purpose designed.

Existing ceilings cannot accommodate a recessed back box.The complete housing installs below the panel with only sealed fixing and cable penetrations.

Sharp enclosure folds trap residue along the ceiling.Rounded transitions and a smooth back perimeter reduce inaccessible crevices.

Conduit knockouts allow moisture into the electrical chamber.A gasketed access plate accepts a matched vapor-tight gland.

Frequent lens removal weakens loose perimeter screws.Retained hinges or cables and captive fasteners control the service frame.

Типичные приложения

Retrofit cleanroomsLow-plenum controlled roomsFood and medical packagingClean utility corridors

Технические параметры

Typical configurable construction ranges for a surface-mounted cleanroom LED luminaire are listed below.

Основной материал	Formed sheet-steel or stainless housing with LED modules, electronic driver and polymer diffuser
Толщина панели	85-155 mm complete surface housing depth
эффективная ширина	300-650 mm exposed fixture width
Максимальная длина	Up to 1250 mm overall luminaire length
Толщина линий стали	0.9-1.2 mm formed steel housing and lens frame
Плотность ядра	Approximately 7850-8000 kg/m³ for steel or stainless housing material
Теплопроводимость	14-60 W/(m·K) depending on stainless or carbon-steel housing
Поверхностная отделка	Smooth white powder coat or fine-brushed stainless steel with an opal lens
Объединенный тип	Closed-back surface body with continuous lens gasket and vapor-tight cable gland plate
Customization	Доступно в зависимости от предполагаемого применения и операционной среды.

Доступные варианты

White coated steel or stainless bodySquare or rectangular formatsTop or end cable entryIntegral emergency driver

Planning a Surface-Mounted Cleanroom Light specification?

Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.

Поговорите с нашей командой