UV-C lamp safety timer controller with keyed switch and digital display

Pencahayaan bilik bersih dan peralatan elektrik

Pengawal Pemasa Lampu UV

A dedicated wall controller that sequences delayed start, timed UV-C operation, warnings and safety interlock inputs from one sealed panel.

Keyed Enable Control
Adjustable Cycle Timer
Delayed Start Warning
Door and Sensor Inputs

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The UV-C controller separates germicidal operation from ordinary room-light switching. Its cleanable front panel carries a key switch, timer display, start/stop controls and status indicators. Inside the enclosure, a contactor or relay output switches the UV-C load while low-voltage terminals accept door contacts, occupancy sensors, warning beacons and remote emergency-stop devices.

Ciri-ciri Utama

A keyed enable switch limits cycle initiation to authorized personnel.

The programmable delay provides a defined exit interval before lamp energization.

A digital display shows remaining treatment time and operating state.

Dedicated safety inputs interrupt the output when a monitored door opens or occupancy is detected.

Separate relay terminals operate external beacons and audible warnings.

Kebimbangan Produk Pelanggan

A basic timer alone cannot manage warning, authorization and interruption functions required around an unattended UV-C cycle.

Anyone can start a germicidal circuit from a normal wall switch.A key-controlled enable stage restricts initiation to designated operators.

Personnel have no time to leave after pressing start.An adjustable countdown drives warnings before the power relay closes.

Opening a door does not stop an independent timer output.Hardwired safety inputs drop the UV-C contactor immediately on an interlock event.

The operator cannot see whether a cycle ended or was interrupted.Distinct display states report standby, delay, active, complete and fault conditions.

Permohonan yang biasa

Fixed UV-C room systemsPass-box germicidal circuitsDuct irradiation controlsLaboratory treatment rooms

Parameter teknikal

Typical configurable construction ranges for a UV-C lamp safety timer controller are listed below.

Bahan Teras	Powder-coated steel or stainless enclosure with programmable timer, contactor, control relays and membrane interface
Ketebalan Panel	90-180 mm wall enclosure depth
Lebar berkesan	180-400 mm front-panel width
Panjang maksimum	Up to 500 mm overall enclosure height
Keluli Menghadapi Ketebalan	1.0-1.5 mm formed steel or stainless enclosure panels
Ketumpatan teras	Approximately 7900-8000 kg/m³ for a stainless enclosure version
Kekonduksian Terma	14-16 W / (m · K) untuk kandung tahan karat
Kemasan permukaan	White powder coat or fine-brushed stainless front with black display and colored status indicators
Jenis Bersatu	Gasketed enclosure door with sealed membrane controls and separated power and low-voltage terminal blocks
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Wall flush or surface enclosureLocal or networked timerDoor, motion and emergency-stop inputsExternal beacon and buzzer outputs

Planning a UV Lamp Timer Controller specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami