High-pressure mist humidifier pump station with nozzle manifold

Bilik Bersih HVAC dan Peralatan Pengendalian Udara

Kelembapkan Kabut Tekanan Tinggi

A high-capacity adiabatic system that pressurizes treated water and atomizes it through precision anti-drip nozzles into an AHU or large controlled space.

Fine High-Pressure Atomization
Low-Energy Adiabatic Operation
Anti-Drip Nozzle Manifold
Integrated Water Treatment

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

A stainless multistage pump raises treated water to high pressure and supplies a manifold of precision nozzles. Each orifice creates a fine mist that evaporates into the airstream, adding moisture while absorbing sensible heat. Filtration and reverse-osmosis pretreatment limit nozzle deposits, and staged nozzle banks or variable pump control match output to demand.

Ciri-ciri Utama

High pressure forms small droplets with a high surface area for rapid adiabatic evaporation.

Stainless pump, tubing and manifold resist continuous purified-water service.

Anti-drip nozzles close positively when pressure falls and reduce post-cycle wetting.

Integrated filtration and treatment protect small orifices from scale and suspended particles.

Kebimbangan Produk Pelanggan

High-pressure systems require fine atomization, clean water and controlled staging so droplets evaporate before reaching surfaces.

Nozzle deposits change spray pattern and create large droplets.Fine filtration and low-mineral treated water protect the precision orifices.

Nozzles drip after the pump stops.Spring-loaded anti-drip valves close each nozzle below operating pressure.

Short duct length does not allow full mist absorption.Nozzle placement, droplet size and staged capacity are matched to airflow and available distance.

A fixed-output pump causes repeated on-off cycling.Variable-speed pressure control or staged nozzle zones follow the actual humidity demand.

Permohonan yang biasa

Large pharmaceutical cleanroomsElectronics manufacturing hallsData-center air handlersPrinting and paper productionIndustrial evaporative cooling and humidification

Parameter teknikal

Representative construction ranges for a packaged high-pressure mist station are listed below.

Bahan Teras	AISI 304 or 316 stainless pump, manifold and tubing with ceramic or stainless nozzles
Ketebalan Panel	1.2-2.0 mm powder-coated control-cabinet panels
Lebar berkesan	600-1800 mm packaged pump-station width
Panjang maksimum	Up to 5000 mm modular nozzle-manifold section length
Keluli Menghadapi Ketebalan	1.2-2.0 mm cabinet and stainless base sheet
Ketumpatan teras	Approximately 7900-8000 kg/m³ for stainless pump, manifold and tubing material
Kekonduksian Terma	Approximately 14-16 W/(m·K) for stainless water-contact parts
Kemasan permukaan	White-blue powder coating with passivated stainless pump and tubing
Jenis Bersatu	Compression-connected high-pressure tubing with threaded anti-drip nozzles and bolted skid
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

In-duct or direct-room nozzle arrangementIntegrated reverse-osmosis and ultraviolet treatmentVariable-speed pump or staged solenoid zonesStainless droplet separator and water-quality monitoring

Planning a High-Pressure Mist Humidifier specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami