High-pressure mist humidifier pump station with nozzle manifold

クリーンルーム HVAC および空気処理装置

高圧ミスト加湿器

A high-capacity adiabatic system that pressurizes treated water and atomizes it through precision anti-drip nozzles into an AHU or large controlled space.

Fine High-Pressure Atomization
Low-Energy Adiabatic Operation
Anti-Drip Nozzle Manifold
Integrated Water Treatment

見積もりリクエスト製品案内

商品紹介

A stainless multistage pump raises treated water to high pressure and supplies a manifold of precision nozzles. Each orifice creates a fine mist that evaporates into the airstream, adding moisture while absorbing sensible heat. Filtration and reverse-osmosis pretreatment limit nozzle deposits, and staged nozzle banks or variable pump control match output to demand.

主要な特徴

High pressure forms small droplets with a high surface area for rapid adiabatic evaporation.

Stainless pump, tubing and manifold resist continuous purified-water service.

Anti-drip nozzles close positively when pressure falls and reduce post-cycle wetting.

Integrated filtration and treatment protect small orifices from scale and suspended particles.

お客様の製品に関する懸念事項

High-pressure systems require fine atomization, clean water and controlled staging so droplets evaporate before reaching surfaces.

Nozzle deposits change spray pattern and create large droplets.Fine filtration and low-mineral treated water protect the precision orifices.

Nozzles drip after the pump stops.Spring-loaded anti-drip valves close each nozzle below operating pressure.

Short duct length does not allow full mist absorption.Nozzle placement, droplet size and staged capacity are matched to airflow and available distance.

A fixed-output pump causes repeated on-off cycling.Variable-speed pressure control or staged nozzle zones follow the actual humidity demand.

典型的な用途

Large pharmaceutical cleanroomsElectronics manufacturing hallsData-center air handlersPrinting and paper productionIndustrial evaporative cooling and humidification

技術的なパラメータ

Representative construction ranges for a packaged high-pressure mist station are listed below.

コア材料	AISI 304 or 316 stainless pump, manifold and tubing with ceramic or stainless nozzles
パネルの厚さ	1.2-2.0 mm powder-coated control-cabinet panels
有効幅	600-1800 mm packaged pump-station width
最大長さ	Up to 5000 mm modular nozzle-manifold section length
鋼鉄の厚さを直面する	1.2-2.0 mm cabinet and stainless base sheet
コア密度	Approximately 7900-8000 kg/m³ for stainless pump, manifold and tubing material
熱伝導率	Approximately 14-16 W/(m·K) for stainless water-contact parts
表面仕上げ	White-blue powder coating with passivated stainless pump and tubing
ジョイントタイプ	Compression-connected high-pressure tubing with threaded anti-drip nozzles and bolted skid
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

In-duct or direct-room nozzle arrangementIntegrated reverse-osmosis and ultraviolet treatmentVariable-speed pump or staged solenoid zonesStainless droplet separator and water-quality monitoring

Planning a High-Pressure Mist Humidifier specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する