High-pressure mist humidifier pump station with nozzle manifold

클린룸 HVAC 및 공기 처리 장비

고압 미스트 가습기 High Pressure Mist Humidifier

A high-capacity adiabatic system that pressurizes treated water and atomizes it through precision anti-drip nozzles into an AHU or large controlled space.

Fine High-Pressure Atomization
Low-Energy Adiabatic Operation
Anti-Drip Nozzle Manifold
Integrated Water Treatment

견적 요청 제품 찾아보기

상품 소개

A stainless multistage pump raises treated water to high pressure and supplies a manifold of precision nozzles. Each orifice creates a fine mist that evaporates into the airstream, adding moisture while absorbing sensible heat. Filtration and reverse-osmosis pretreatment limit nozzle deposits, and staged nozzle banks or variable pump control match output to demand.

주요 기능

High pressure forms small droplets with a high surface area for rapid adiabatic evaporation.

Stainless pump, tubing and manifold resist continuous purified-water service.

Anti-drip nozzles close positively when pressure falls and reduce post-cycle wetting.

Integrated filtration and treatment protect small orifices from scale and suspended particles.

고객 제품 관심사

High-pressure systems require fine atomization, clean water and controlled staging so droplets evaporate before reaching surfaces.

Nozzle deposits change spray pattern and create large droplets.Fine filtration and low-mineral treated water protect the precision orifices.

Nozzles drip after the pump stops.Spring-loaded anti-drip valves close each nozzle below operating pressure.

Short duct length does not allow full mist absorption.Nozzle placement, droplet size and staged capacity are matched to airflow and available distance.

A fixed-output pump causes repeated on-off cycling.Variable-speed pressure control or staged nozzle zones follow the actual humidity demand.

일반적인 응용 프로그램

Large pharmaceutical cleanroomsElectronics manufacturing hallsData-center air handlersPrinting and paper productionIndustrial evaporative cooling and humidification

기술 매개변수

Representative construction ranges for a packaged high-pressure mist station are listed below.

핵심 재료	AISI 304 or 316 stainless pump, manifold and tubing with ceramic or stainless nozzles
패널 두께	1.2-2.0 mm powder-coated control-cabinet panels
유효 폭	600-1800 mm packaged pump-station width
최대 길이	Up to 5000 mm modular nozzle-manifold section length
강철 면면 두께	1.2-2.0 mm cabinet and stainless base sheet
코어 밀도	Approximately 7900-8000 kg/m³ for stainless pump, manifold and tubing material
열전도도 (Thermal Conductivity)	Approximately 14-16 W/(m·K) for stainless water-contact parts
표면 마무리	White-blue powder coating with passivated stainless pump and tubing
접합 유형	Compression-connected high-pressure tubing with threaded anti-drip nozzles and bolted skid
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

In-duct or direct-room nozzle arrangementIntegrated reverse-osmosis and ultraviolet treatmentVariable-speed pump or staged solenoid zonesStainless droplet separator and water-quality monitoring

Planning a High-Pressure Mist Humidifier specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.