Three-quarter view of a galvanized cleanroom duct trapeze hanger

Aksesori Pemasangan Bilik Bersih

Hanger saluran

An adjustable galvanized trapeze hanger with two threaded rods and a slotted channel crossbar for suspending rectangular cleanroom ductwork.

Twin Threaded Rods
Slotted Channel Crossbar
Independent Level Adjustment
Galvanized Steel Hardware

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The duct hanger forms a rigid trapeze below the structural attachment points. Two continuously threaded rods pass through the ends of a galvanized slotted C-channel and are retained by paired nuts and washers, allowing installers to set crossbar elevation and level before the duct is seated. The open channel accepts compatible saddles or restraint hardware without requiring holes to be drilled through the supported duct casing.

Ciri-ciri Utama

Two threaded rods provide independent elevation adjustment at both ends of the crossbar.

A slotted C-channel permits flexible positioning of compatible duct restraint hardware.

Broad washer stacks distribute clamping load at the rod-to-channel interfaces.

Zinc-plated steel offers a practical finish for dry indoor service plenums.

Kebimbangan Produk Pelanggan

Rectangular duct runs require a level, distributed support that can be adjusted around uneven overhead structure without puncturing the duct casing.

Fixed-length hangers make it difficult to level ductwork below an uneven soffit.Independent nuts on the two threaded rods allow each end of the channel to be adjusted separately.

Narrow point supports can distort light-gauge rectangular duct walls.The channel crossbar provides a continuous bearing line beneath the duct or its support saddle.

Drilling the duct casing creates avoidable leakage and contamination traps.The trapeze supports the duct externally and accepts separate restraint hardware through its slots.

Bare carbon-steel hardware can develop surface corrosion in service voids.Galvanized or stainless hardware can be selected to suit the plenum exposure.

Permohonan yang biasa

Rectangular cleanroom supply duct suspensionReturn-air duct trapeze supportsExhaust duct support framesAir-handler connection supportService-plenum HVAC installations

Parameter teknikal

Typical construction ranges for an adjustable galvanized cleanroom duct trapeze hanger are listed below.

Bahan Teras	Galvanized carbon-steel C-channel, threaded rods, nuts, washers and anchor plates
Ketebalan Panel	0.60-2.00 mm compatible rectangular duct wall thickness
Lebar berkesan	200-1500 mm adjustable duct support width
Panjang maksimum	Up to 2000 mm slotted channel crossbar length
Keluli Menghadapi Ketebalan	1.50-3.00 mm nominal channel wall thickness
Ketumpatan teras	Approximately 7850 kg/m³ for carbon-steel components
Kekonduksian Terma	Approximately 45-60 W/(m·K) for carbon steel
Kemasan permukaan	Silver electro-galvanized or hot-dip galvanized steel
Jenis Bersatu	Twin threaded-rod trapeze with nut-and-washer clamped slotted channel
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

M8, M10 or M12 threaded rodsElectro-galvanized, hot-dip galvanized or stainless steelCustom crossbar width and slot patternOptional elastomer isolation strip or duct saddle

Planning a Duct Hanger specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami