Three-quarter view of a galvanized cleanroom duct trapeze hanger

クリーンルームの設置付属品

ダクトハンガー

An adjustable galvanized trapeze hanger with two threaded rods and a slotted channel crossbar for suspending rectangular cleanroom ductwork.

Twin Threaded Rods
Slotted Channel Crossbar
Independent Level Adjustment
Galvanized Steel Hardware

見積もりリクエスト製品案内

商品紹介

The duct hanger forms a rigid trapeze below the structural attachment points. Two continuously threaded rods pass through the ends of a galvanized slotted C-channel and are retained by paired nuts and washers, allowing installers to set crossbar elevation and level before the duct is seated. The open channel accepts compatible saddles or restraint hardware without requiring holes to be drilled through the supported duct casing.

主要な特徴

Two threaded rods provide independent elevation adjustment at both ends of the crossbar.

A slotted C-channel permits flexible positioning of compatible duct restraint hardware.

Broad washer stacks distribute clamping load at the rod-to-channel interfaces.

Zinc-plated steel offers a practical finish for dry indoor service plenums.

お客様の製品に関する懸念事項

Rectangular duct runs require a level, distributed support that can be adjusted around uneven overhead structure without puncturing the duct casing.

Fixed-length hangers make it difficult to level ductwork below an uneven soffit.Independent nuts on the two threaded rods allow each end of the channel to be adjusted separately.

Narrow point supports can distort light-gauge rectangular duct walls.The channel crossbar provides a continuous bearing line beneath the duct or its support saddle.

Drilling the duct casing creates avoidable leakage and contamination traps.The trapeze supports the duct externally and accepts separate restraint hardware through its slots.

Bare carbon-steel hardware can develop surface corrosion in service voids.Galvanized or stainless hardware can be selected to suit the plenum exposure.

典型的な用途

Rectangular cleanroom supply duct suspensionReturn-air duct trapeze supportsExhaust duct support framesAir-handler connection supportService-plenum HVAC installations

技術的なパラメータ

Typical construction ranges for an adjustable galvanized cleanroom duct trapeze hanger are listed below.

コア材料	Galvanized carbon-steel C-channel, threaded rods, nuts, washers and anchor plates
パネルの厚さ	0.60-2.00 mm compatible rectangular duct wall thickness
有効幅	200-1500 mm adjustable duct support width
最大長さ	Up to 2000 mm slotted channel crossbar length
鋼鉄の厚さを直面する	1.50-3.00 mm nominal channel wall thickness
コア密度	Approximately 7850 kg/m³ for carbon-steel components
熱伝導率	Approximately 45-60 W/(m·K) for carbon steel
表面仕上げ	Silver electro-galvanized or hot-dip galvanized steel
ジョイントタイプ	Twin threaded-rod trapeze with nut-and-washer clamped slotted channel
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

M8, M10 or M12 threaded rodsElectro-galvanized, hot-dip galvanized or stainless steelCustom crossbar width and slot patternOptional elastomer isolation strip or duct saddle

Planning a Duct Hanger specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する