Three-quarter view of a galvanized cleanroom duct trapeze hanger

클린룸 설치 액세서리

덕트 걸러

An adjustable galvanized trapeze hanger with two threaded rods and a slotted channel crossbar for suspending rectangular cleanroom ductwork.

Twin Threaded Rods
Slotted Channel Crossbar
Independent Level Adjustment
Galvanized Steel Hardware

견적 요청 제품 찾아보기

상품 소개

The duct hanger forms a rigid trapeze below the structural attachment points. Two continuously threaded rods pass through the ends of a galvanized slotted C-channel and are retained by paired nuts and washers, allowing installers to set crossbar elevation and level before the duct is seated. The open channel accepts compatible saddles or restraint hardware without requiring holes to be drilled through the supported duct casing.

주요 기능

Two threaded rods provide independent elevation adjustment at both ends of the crossbar.

A slotted C-channel permits flexible positioning of compatible duct restraint hardware.

Broad washer stacks distribute clamping load at the rod-to-channel interfaces.

Zinc-plated steel offers a practical finish for dry indoor service plenums.

고객 제품 관심사

Rectangular duct runs require a level, distributed support that can be adjusted around uneven overhead structure without puncturing the duct casing.

Fixed-length hangers make it difficult to level ductwork below an uneven soffit.Independent nuts on the two threaded rods allow each end of the channel to be adjusted separately.

Narrow point supports can distort light-gauge rectangular duct walls.The channel crossbar provides a continuous bearing line beneath the duct or its support saddle.

Drilling the duct casing creates avoidable leakage and contamination traps.The trapeze supports the duct externally and accepts separate restraint hardware through its slots.

Bare carbon-steel hardware can develop surface corrosion in service voids.Galvanized or stainless hardware can be selected to suit the plenum exposure.

일반적인 응용 프로그램

Rectangular cleanroom supply duct suspensionReturn-air duct trapeze supportsExhaust duct support framesAir-handler connection supportService-plenum HVAC installations

기술 매개변수

Typical construction ranges for an adjustable galvanized cleanroom duct trapeze hanger are listed below.

핵심 재료	Galvanized carbon-steel C-channel, threaded rods, nuts, washers and anchor plates
패널 두께	0.60-2.00 mm compatible rectangular duct wall thickness
유효 폭	200-1500 mm adjustable duct support width
최대 길이	Up to 2000 mm slotted channel crossbar length
강철 면면 두께	1.50-3.00 mm nominal channel wall thickness
코어 밀도	Approximately 7850 kg/m³ for carbon-steel components
열전도도 (Thermal Conductivity)	Approximately 45-60 W/(m·K) for carbon steel
표면 마무리	Silver electro-galvanized or hot-dip galvanized steel
접합 유형	Twin threaded-rod trapeze with nut-and-washer clamped slotted channel
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

M8, M10 or M12 threaded rodsElectro-galvanized, hot-dip galvanized or stainless steelCustom crossbar width and slot patternOptional elastomer isolation strip or duct saddle

Planning a Duct Hanger specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.