Complete hygienic explosion vent and stainless clamping frame in three-quarter view

클린룸 배수, 위생 및 안전 장비

폭발 통풍기

A rupture-membrane vent that opens rapidly to relieve explosion pressure from process vessels and dust collectors.

Fast Rupture-Membrane Opening
Hygienic Stainless Frame
Low-Leakage Perimeter Seal
Optional Burst Detection

견적 요청 제품 찾아보기

상품 소개

The explosion vent mounts over a calculated relief opening on a vessel, collector or duct. A scored or domed membrane remains sealed under normal pressure and ruptures at its specified burst condition, providing a large low-inertia discharge area. The clamping frame, gasket and support arrangement are selected for pressure cycling, temperature and cleaning conditions.

주요 기능

Low-mass rupture membrane provides rapid full-area opening.

A perimeter gasket maintains normal process containment.

Stainless construction supports hygienic and corrosion-sensitive service.

A burst sensor can initiate shutdown and alarm sequences.

고객 제품 관심사

Combustible dust equipment needs rapid pressure relief without allowing normal product leakage or contamination around the opening.

A heavy door responds too slowly to a fast pressure rise.A low-inertia rupture membrane opens across its designed relief area.

Pressure cycling fatigues an unsuitable vent element.Membrane profile and support are selected for the normal vacuum and pressure cycle.

Product and wash liquid can collect at rough frame joints.A stainless hygienic frame and continuous compatible gasket reduce crevices.

A burst event must stop connected equipment.An optional rupture indicator sends an immediate interlock signal.

일반적인 응용 프로그램

Dust collectorsPowder process vesselsHygienic conveying systemsFilter and dryer equipment

기술 매개변수

Typical physical construction is listed below; vent area, burst pressure and discharge routing require process-specific explosion-protection engineering.

핵심 재료	AISI 304 or 316L stainless rupture membrane and clamping frame
패널 두께	0.2-1.0 mm engineered rupture membrane
유효 폭	150-1000 mm nominal opening width
최대 길이	Up to 1500 mm vent dimension
강철 면면 두께	0.2-1.0 mm rupture membrane surface
코어 밀도	7900-8000 kg/m³ for stainless components
열전도도 (Thermal Conductivity)	14-16 W/(m·K) for stainless components
표면 마무리	Satin, pickled or electropolished stainless
접합 유형	Gasketed bolted clamping frame with replaceable rupture element
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Flat or domed membrane316L hygienic frameBurst indicatorCircular or rectangular opening

Planning a Explosion Vent specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.