Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Sistemas de pared y techo de sala limpia
Acero inoxidable sala limpia Crash Rail
A wall-mounted 304 or 316L stainless steel rail that intercepts carts and mobile equipment before they damage cleanroom panels, glazing or built-in services.
- Heavy-Duty Wall Protection
- Concealed Rear Brackets
- 304 or 316L Stainless Steel
- Rounded Cleanable Edges
Introducción del producto
Stainless Steel Cleanroom Crash Rails create a continuous impact line along busy cleanroom corridors and material routes. A thick flat bar or formed rail is spaced from the wall on welded rear studs and Z-brackets, allowing trolley frames and carts to contact the guard before reaching the finished panel. Concealed front fixings leave a smooth exposed surface, and rounded or fully welded ends remove sharp edges. Standard 304 stainless steel covers most dry interiors; 316L and alternative polishing are available for higher chemical or wash-down exposure.
Características clave
Rear-mounted brackets eliminate exposed fastener heads from the impact face.
The wall offset can clear coving, service panels and minor surface projections.
Rounded ends and smooth welds avoid sharp corners along pedestrian routes.
Modular rail lengths can be joined around corridors while maintaining a consistent protection height.
Preocupaciones del producto del cliente
A crash rail must protect the wall at the correct impact height, transfer loads into sound supports and remain accessible for cleaning behind the rail.
Cart frames strike the wall above low skirting and dent cleanroom panels.The rail is mounted at the actual equipment contact height to intercept horizontal movement.
Weak surface fixings pull out of thin panel skins under repeated contact.Rear brackets align with internal reinforcement or independent wall support points.
A rail mounted too close to the wall leaves no room to wipe behind it.A controlled stand-off creates cleaning access without projecting unnecessarily into the corridor.
Open tube ends and rough welds become contamination traps.Closed rounded ends and dressed welds keep the guard smooth and fully cleanable.
Aplicaciones típicas
Cleanroom material corridorsPharmaceutical warehouse interfacesHospital sterile supply routesFood-production trolley lanesLaboratory equipment movement areas
Parámetros técnicos
Typical stainless steel cleanroom crash-rail dimensions are shown below.
| Materiales Core | Solid AISI 304 stainless steel; 316L optional |
|---|---|
| Panel de espesor | 6 mm flat-bar thickness |
| Ancho efectivo | 76, 102 or 152 mm rail height |
| Longitud máxima | 3000 mm per section |
| Acero frente a espesor | 6 mm stainless steel rail |
| Densidad Core | N/A — solid stainless steel construction |
| Conductividad térmica | N/A — wall protection component, not insulation |
| Superficie acabada | ASTM No. 4 or 320-grit satin polished stainless steel |
| Tipo conjunto | Rear welded studs on concealed Z-brackets with closed end caps |
| Customization | Disponible según la aplicación prevista y el entorno operativo |
Opciones disponibles
304 or 316L stainless steel76, 102 and 152 mm heights38–150 mm wall stand-offStraight, corner and returned-end sections
Planning a Stainless Steel Cleanroom Crash Rail specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
