Complete stainless steel cleanroom crash rail with concealed brackets

Dinding bilik bersih dan sistem siling

Kereta Api Kemalangan Bilik Bersih keluli tahan karat

A wall-mounted 304 or 316L stainless steel rail that intercepts carts and mobile equipment before they damage cleanroom panels, glazing or built-in services.

Heavy-Duty Wall Protection
Concealed Rear Brackets
304 or 316L Stainless Steel
Rounded Cleanable Edges

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

Stainless Steel Cleanroom Crash Rails create a continuous impact line along busy cleanroom corridors and material routes. A thick flat bar or formed rail is spaced from the wall on welded rear studs and Z-brackets, allowing trolley frames and carts to contact the guard before reaching the finished panel. Concealed front fixings leave a smooth exposed surface, and rounded or fully welded ends remove sharp edges. Standard 304 stainless steel covers most dry interiors; 316L and alternative polishing are available for higher chemical or wash-down exposure.

Ciri-ciri Utama

A rigid stainless rail receives horizontal trolley loads before wheels or frames reach the wall panel.

Rear-mounted brackets eliminate exposed fastener heads from the impact face.

The wall offset can clear coving, service panels and minor surface projections.

Rounded ends and smooth welds avoid sharp corners along pedestrian routes.

Modular rail lengths can be joined around corridors while maintaining a consistent protection height.

Kebimbangan Produk Pelanggan

A crash rail must protect the wall at the correct impact height, transfer loads into sound supports and remain accessible for cleaning behind the rail.

Cart frames strike the wall above low skirting and dent cleanroom panels.The rail is mounted at the actual equipment contact height to intercept horizontal movement.

Weak surface fixings pull out of thin panel skins under repeated contact.Rear brackets align with internal reinforcement or independent wall support points.

A rail mounted too close to the wall leaves no room to wipe behind it.A controlled stand-off creates cleaning access without projecting unnecessarily into the corridor.

Open tube ends and rough welds become contamination traps.Closed rounded ends and dressed welds keep the guard smooth and fully cleanable.

Permohonan yang biasa

Cleanroom material corridorsPharmaceutical warehouse interfacesHospital sterile supply routesFood-production trolley lanesLaboratory equipment movement areas

Parameter teknikal

Typical stainless steel cleanroom crash-rail dimensions are shown below.

Bahan Teras	Solid AISI 304 stainless steel; 316L optional
Ketebalan Panel	6 mm flat-bar thickness
Lebar berkesan	76, 102 or 152 mm rail height
Panjang maksimum	3000 mm setiap bahagian
Keluli Menghadapi Ketebalan	6 mm stainless steel rail
Ketumpatan teras	N/A — solid stainless steel construction
Kekonduksian Terma	N/A — wall protection component, not insulation
Kemasan permukaan	ASTM No. 4 or 320-grit satin polished stainless steel
Jenis Bersatu	Rear welded studs on concealed Z-brackets with closed end caps
Penyesuaian	Terdapat berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi

Pilihan yang boleh didapati

304 or 316L stainless steel76, 102 and 152 mm heights38–150 mm wall stand-offStraight, corner and returned-end sections

Planning a Stainless Steel Cleanroom Crash Rail specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami