Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Equipos de sala limpia piezas de repuesto
AHU Fan Belt
A fabric-wrapped classical V-belt for restoring matched torque transmission between an AHU fan motor pulley and blower sheave.
- Wrapped V Profile
- Reinforced Tension Cords
- Matched Pulley Contact
- HVAC Drive Replacement
Introducción del producto
The AHU fan belt is an endless trapezoidal power-transmission belt used between the motor pulley and fan shaft sheave of a belt-driven air-handling unit. A resilient elastomer body transfers load through the pulley groove, longitudinal tension cords control stretch, and a fabric wrap protects the working surfaces from abrasion. Correct replacement depends on profile, datum or pitch length, matched-set tolerance, pulley condition and installation tension. A new belt should not be forced over a sheave and multiple-belt drives require a length-matched set rather than a mixture of new and worn belts.
Características clave
Longitudinal tensile cords limit elongation while repeatedly flexing around the motor and fan sheaves.
The wrapped fabric cover protects the belt flanks and outer surface against handling wear and repeated groove contact.
A continuous molded body avoids mechanical joints and supports even load transfer around the entire belt circumference.
Preocupaciones del producto del cliente
Fan-drive reliability depends on selecting the exact section and effective length, then installing it on aligned pulleys at the specified tension.
A belt with the wrong cross-section rides too high or too low in the pulley groove and cannot transmit load correctly.Top width, section height and groove profile are matched to the existing sheaves before the replacement is supplied.
An incorrect effective length can leave too little adjustment for proper tension or overload the shaft bearings.The existing belt designation and measured drive geometry are used to select the appropriate datum or pitch length.
Replacing only one belt in a multi-groove drive causes unequal load sharing between old and new belts.Parallel drives are serviced with a factory-matched set of equal-length belts installed at the same time.
Pulley misalignment and excessive pretension accelerate flank wear, heat generation and vibration.The belt is paired with inspected, aligned sheaves and tensioned by the AHU maintenance procedure rather than levered into place.
Aplicaciones típicas
Belt-driven AHU supply fansReturn-air blower drivesCleanroom exhaust fan sectionsVentilation equipment replacement maintenance
Parámetros técnicos
Typical material construction and dimensional ranges for wrapped classical AHU fan V-belts are listed below.
| Materiales Core | Synthetic-rubber compression body with polyester tension cords and woven fabric wrap |
|---|---|
| Panel de espesor | 6-32 mm nominal belt section height, depending on profile |
| Ancho efectivo | 10-40 mm nominal top width, depending on classical V-belt section |
| Longitud máxima | Up to 5000 mm nominal datum length for common AHU drive selections |
| Acero frente a espesor | 0 mm; nonmetallic wrapped belt construction |
| Densidad Core | Approximately 1100-1300 kg/m³ for reinforced rubber composite |
| Conductividad térmica | Approximately 0.15-0.25 W/(m·K) for the rubber-fabric composite |
| Superficie acabada | Matte black friction-resistant woven fabric wrap over all external belt faces |
| Tipo conjunto | Continuous molded endless loop with trapezoidal sidewalls for V-grooved pulleys |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
Classical Z, A, B, C or D profileMatched multi-belt setAlternative effective lengthWrapped or raw-edge construction
Planning a AHU Fan Belt specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
