Precision temperature and humidity control air-conditioning unit

클린룸 HVAC 및 공기 처리 장비

정밀 온도 및 습도 제어 장치

A close-control air-conditioning unit that coordinates cooling, reheat, humidification and airflow to hold stable cleanroom temperature and moisture conditions.

Coordinated Cooling and Reheat
Stable Humidity Control
Modulating Airflow
Remote Monitoring Ready

견적 요청 제품 찾아보기

상품 소개

The precision temperature and humidity control unit responds to small thermal and moisture changes that conventional comfort equipment may ignore. A modulating cooling stage removes sensible heat and moisture, reheat prevents overcooling during dehumidification, and humidification adds controlled moisture during dry conditions. Direct-drive fans maintain airflow through filter loading, while separate temperature and humidity sensors support stable control. The unit is suited to laboratories, metrology rooms and clean processes with narrow operating bands.

주요 기능

Cooling and reheat outputs are coordinated to control moisture without allowing room temperature to drift.

Modulating valves, inverter compressors or staged circuits provide finer response than simple on-off control.

Remote supply and return sensors can distinguish room conditions from local unit casing effects.

Trendable alarms for temperature, humidity, airflow and filter loading support early intervention.

고객 제품 관심사

Tight environmental control requires all heating, cooling, humidifying and airflow functions to respond as one system rather than as independent devices.

Dehumidification lowers room temperature below the operating band.Modulating reheat offsets the sensible cooling remaining after moisture removal.

Oversized on-off cooling cycles cause repeated humidity swings.Variable or staged capacity matches smaller loads and reduces short cycling.

A sensor near the supply outlet does not represent the controlled workspace.Remote room sensors and averaged feedback are positioned at representative locations.

Filter loading changes airflow and alters coil moisture removal.Fan-speed control maintains airflow while differential-pressure monitoring signals service need.

일반적인 응용 프로그램

Metrology and calibration roomsPharmaceutical laboratoriesMedical-device inspectionElectronics test cleanroomsStability and environmental rooms

기술 매개변수

Typical insulated casing construction for a precision environmental control unit is listed below.

핵심 재료	Closed-cell polyurethane insulation in thermally separated equipment panels
패널 두께	40–60 mm insulated casing panel
유효 폭	700–2200 mm nominal unit width
최대 길이	Up to 4500 mm overall equipment length
강철 면면 두께	0.6–1.0 mm coated steel casing skins
코어 밀도	40–45 kg/m³ closed-cell polyurethane
열전도도 (Thermal Conductivity)	0.023–0.026 W/(m·K) for precision-unit casing insulation
표면 마무리	Textured powder-coated exterior with galvanized or stainless internal wet-section surfaces
접합 유형	Gasketed equipment panels with sealed coil section and flexible supply/return connections
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Chilled-water or inverter DX coolingElectric, hot-water or hot-gas reheatSteam or electrode humidifierDuty/standby fan or refrigeration circuit arrangement

Planning a Precision Temperature and Humidity Control Unit specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.