Flush-mounted cleanroom junction box with flat stainless access cover

Cleanroom Lighting dan Peralatan Listrik

Kotak Junction Flush-Mounted

A recessed wiring enclosure with a flat removable cover that keeps splices accessible without a projecting industrial box.

Flush Removable Cover
Concealed Perimeter Seal
Captive Countersunk Screws
Sealed Internal Cable Entries

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The junction box sits inside the cleanroom wall panel and presents only a flat stainless access cover to the room. A continuous gasket seals the cover to the recessed frame and countersunk captive screws distribute compression around the edge. Internal DIN rail, terminals and cable glands organize branch wiring while remaining outside the primary cleaning surface.

Fitur utama:

The cover aligns closely with the wall plane and eliminates a projecting enclosure.

Captive screws remain attached during electrical access.

A continuous seal prevents the wall cavity from opening into the room.

Internal earth studs and terminal rail provide an organized bonding point.

Rear and side gland plates route cables without field-cut openings in the face.

Kekhawatiran produk pelanggan

Electrical splices require future access, but a removable panel can compromise wall integrity if its cover and cable routes are not sealed.

A surface junction box creates a large top ledge.The enclosure recesses fully behind a flush access plate.

Loose cover screws fall into the controlled room.Captive countersunk fasteners remain retained in the plate.

Unsealed cable holes connect the room to the wall cavity.Matched glands close each conductor route inside the back box.

Mixed splices make troubleshooting slow and error prone.Labeled DIN terminals and earth studs organize each circuit.

Aplikasi yang Tipis

Cleanroom lighting branchesInstrumentation splicesAccess-control wiringWall-panel service distribution

Parameter teknis

Typical configurable construction ranges for a flush-mounted junction box are listed below.

Bahan inti	SUS304 or SUS316L cover and frame with galvanized or stainless recessed box, DIN rail and terminal blocks
Ketebalan Panel (Panel Thickness)	1.5-3.0 mm flush access-cover thickness
Efektif lebar	150-600 mm clear internal box width
Panjang maksimum	Up to 800 mm overall recessed enclosure height
Baja menghadap ketebalan	1.5-2.0 mm cover; 1.0-1.5 mm recessed box
Kepadatan inti (core density)	Approximately 7900-8000 kg/m³ for the stainless cover and frame
Konduktivitas Termal (Thermal Conductivity)	14-16 W/(m·K) for the stainless access plate
Permukaan selesai	Fine-brushed or electropolished flush stainless cover with engraved circuit reference
Jenis Bersama	Gasketed recessed frame with captive countersunk cover screws and gland-sealed rear entries
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Blank box or fitted DIN terminalsSquare or rectangular coverQuarter-turn latches or captive screwsStainless or galvanized rear enclosure

Planning a Flush-Mounted Junction Box specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami