Flush-mounted cleanroom junction box with flat stainless access cover

클린룸 조명 및 전기 장비

플래시 장착 Junction Box

A recessed wiring enclosure with a flat removable cover that keeps splices accessible without a projecting industrial box.

Flush Removable Cover
Concealed Perimeter Seal
Captive Countersunk Screws
Sealed Internal Cable Entries

견적 요청 제품 찾아보기

상품 소개

The junction box sits inside the cleanroom wall panel and presents only a flat stainless access cover to the room. A continuous gasket seals the cover to the recessed frame and countersunk captive screws distribute compression around the edge. Internal DIN rail, terminals and cable glands organize branch wiring while remaining outside the primary cleaning surface.

주요 기능

The cover aligns closely with the wall plane and eliminates a projecting enclosure.

Captive screws remain attached during electrical access.

A continuous seal prevents the wall cavity from opening into the room.

Internal earth studs and terminal rail provide an organized bonding point.

Rear and side gland plates route cables without field-cut openings in the face.

고객 제품 관심사

Electrical splices require future access, but a removable panel can compromise wall integrity if its cover and cable routes are not sealed.

A surface junction box creates a large top ledge.The enclosure recesses fully behind a flush access plate.

Loose cover screws fall into the controlled room.Captive countersunk fasteners remain retained in the plate.

Unsealed cable holes connect the room to the wall cavity.Matched glands close each conductor route inside the back box.

Mixed splices make troubleshooting slow and error prone.Labeled DIN terminals and earth studs organize each circuit.

일반적인 응용 프로그램

Cleanroom lighting branchesInstrumentation splicesAccess-control wiringWall-panel service distribution

기술 매개변수

Typical configurable construction ranges for a flush-mounted junction box are listed below.

핵심 재료	SUS304 or SUS316L cover and frame with galvanized or stainless recessed box, DIN rail and terminal blocks
패널 두께	1.5-3.0 mm flush access-cover thickness
유효 폭	150-600 mm clear internal box width
최대 길이	Up to 800 mm overall recessed enclosure height
강철 면면 두께	1.5-2.0 mm cover; 1.0-1.5 mm recessed box
코어 밀도	Approximately 7900-8000 kg/m³ for the stainless cover and frame
열전도도 (Thermal Conductivity)	14-16 W/(m·K) for the stainless access plate
표면 마무리	Fine-brushed or electropolished flush stainless cover with engraved circuit reference
접합 유형	Gasketed recessed frame with captive countersunk cover screws and gland-sealed rear entries
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Blank box or fitted DIN terminalsSquare or rectangular coverQuarter-turn latches or captive screwsStainless or galvanized rear enclosure

Planning a Flush-Mounted Junction Box specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.