Flush-mounted cleanroom junction box with flat stainless access cover

クリーンルーム照明 · 電気機器

フラッシュマウント式ジャンクションボックス

A recessed wiring enclosure with a flat removable cover that keeps splices accessible without a projecting industrial box.

Flush Removable Cover
Concealed Perimeter Seal
Captive Countersunk Screws
Sealed Internal Cable Entries

見積もりリクエスト製品案内

商品紹介

The junction box sits inside the cleanroom wall panel and presents only a flat stainless access cover to the room. A continuous gasket seals the cover to the recessed frame and countersunk captive screws distribute compression around the edge. Internal DIN rail, terminals and cable glands organize branch wiring while remaining outside the primary cleaning surface.

主要な特徴

The cover aligns closely with the wall plane and eliminates a projecting enclosure.

Captive screws remain attached during electrical access.

A continuous seal prevents the wall cavity from opening into the room.

Internal earth studs and terminal rail provide an organized bonding point.

Rear and side gland plates route cables without field-cut openings in the face.

お客様の製品に関する懸念事項

Electrical splices require future access, but a removable panel can compromise wall integrity if its cover and cable routes are not sealed.

A surface junction box creates a large top ledge.The enclosure recesses fully behind a flush access plate.

Loose cover screws fall into the controlled room.Captive countersunk fasteners remain retained in the plate.

Unsealed cable holes connect the room to the wall cavity.Matched glands close each conductor route inside the back box.

Mixed splices make troubleshooting slow and error prone.Labeled DIN terminals and earth studs organize each circuit.

典型的な用途

Cleanroom lighting branchesInstrumentation splicesAccess-control wiringWall-panel service distribution

技術的なパラメータ

Typical configurable construction ranges for a flush-mounted junction box are listed below.

コア材料	SUS304 or SUS316L cover and frame with galvanized or stainless recessed box, DIN rail and terminal blocks
パネルの厚さ	1.5-3.0 mm flush access-cover thickness
有効幅	150-600 mm clear internal box width
最大長さ	Up to 800 mm overall recessed enclosure height
鋼鉄の厚さを直面する	1.5-2.0 mm cover; 1.0-1.5 mm recessed box
コア密度	Approximately 7900-8000 kg/m³ for the stainless cover and frame
熱伝導率	14-16 W/(m·K) for the stainless access plate
表面仕上げ	Fine-brushed or electropolished flush stainless cover with engraved circuit reference
ジョイントタイプ	Gasketed recessed frame with captive countersunk cover screws and gland-sealed rear entries
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Blank box or fitted DIN terminalsSquare or rectangular coverQuarter-turn latches or captive screwsStainless or galvanized rear enclosure

Planning a Flush-Mounted Junction Box specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する