Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Salle blanche HVAC et équipement de manutention de l'air
Bobine de réchauffement à eau chaude
A shallow one- or two-row hydronic coil that restores neutral supply-air temperature after deep cooling and dehumidification.
- Post-Dehumidification Reheat
- Shallow Low-Pressure-Drop Face
- Fast Valve Response
- Compact AHU Integration
Introduction de produit
The reheat coil is positioned downstream of a cooling coil so it can add sensible heat without increasing air moisture. Its shallow copper-tube and aluminum-fin construction minimizes air pressure drop while providing enough surface area for precise leaving-temperature control. Low water volume and short circuits respond quickly to a modulating valve, making the coil suitable for tight cleanroom temperature and humidity sequences.
Key Features
Small internal water volume responds rapidly when the modulating valve changes position.
Accessible vents and drains prevent air binding during low-flow operation.
Compact casing fits between cooling-coil, fan and final-filter sections in constrained AHUs.
Préoccupations du client produit
Reheat must correct overcooled supply air precisely without adding excessive pressure drop or fighting the cooling sequence.
Air leaves the dehumidifying coil too cold for the occupied zone.A downstream hydronic coil adds only sensible heat and preserves the achieved moisture content.
An oversized multi-row coil causes sluggish temperature control.A shallow low-volume circuit responds quickly to modulating water flow.
Excessive fin resistance increases cleanroom fan power.A one- or two-row face and appropriate fin pitch minimize air-side pressure drop.
Simultaneous cooling and reheat waste plant energy.Heat-recovery or low-temperature return water can supply the reheat duty when available.
Les applications typiques
Cleanroom temperature-humidity decouplingLaboratory dehumidification reheatHospital operating-room AHUsPharmaceutical make-up air unitsNeutral-temperature supply-air systems
Paramètres techniques
Typical physical ranges for a compact AHU hot-water reheat coil are summarized below.
| Matériaux de base | Copper tubes with aluminum fins and compact copper headers |
|---|---|
| Panneau épaisseur | 1.2-1.8 mm galvanized steel casing |
| Largeur effective | 250-2200 mm active fin face width |
| Longueur maximale | Up to 3200 mm overall casing length |
| Acier face épaisseur | 1.2-1.8 mm galvanized or stainless frame |
| Densité Core | Approximately 2730 kg/m³ for the thin 3003 aluminum fin stock in the shallow reheat section |
| Conductivité thermique | Approximately 193 W/(m·K) for the 3003 aluminum reheat fins at room temperature |
| surface finie | Natural or coated aluminum fins with bright galvanized casing |
| Type joint | Brazed copper tube/header joints inside a shallow flanged casing |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
One- or two-row circuitHeat-recovery, boiler-water or heat-pump-water serviceDifferent fin pitch and protective coatingsStainless casing with vent, drain and sensor pocket
Planning a Hot-Water Reheat Coil specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
