Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Portes de salle blanche, fenêtres et systèmes de verrouillage
Cleanroom Dispositif de sortie de panique
A full-width horizontal touch bar that retracts the exit latch when pushed anywhere across the active surface during emergency egress.
- Full-Width Touch Operation
- Positive Latch Retraction
- Low-Profile Rail
- Interior Emergency Egress
Introduction de produit
The cleanroom panic exit device mounts across the inside face of an exit door and converts pressure on the touch rail into immediate latch retraction. An aluminum chassis carries the linkage between the active bar and the stainless latch case, while black end covers and a narrow red safety accent identify the operating surface. The external side can accept a controlled trim handle without defeating free egress from the clean side.
Key Features
A protected linkage transfers bar travel directly to the latch bolt at the door edge.
Smooth anodized and coated surfaces reduce crevices compared with exposed crossbar hardware.
Optional exterior trim allows controlled entry while the interior touch bar remains freely operable.
Préoccupations du client produit
Emergency hardware must release intuitively under body pressure while still seating the door securely during normal cleanroom operation.
A small lever is difficult to locate or operate while carrying equipment during evacuation.The horizontal touch surface retracts the latch anywhere along the active rail.
Bulky crossbar mechanisms create exposed pivots and cleaning obstacles.The low-profile enclosed rail protects the internal linkage behind smooth covers.
Uncontrolled outside entry compromises the restricted cleanroom boundary.Compatible exterior trim can remain access-controlled while interior egress stays available.
Les applications typiques
Cleanroom emergency exit doorsLaboratory escape routesHospital controlled-area exitsPharmaceutical production corridors
Paramètres techniques
Representative dimensions and materials for a low-profile cleanroom panic touch bar are provided below.
| Matériaux de base | Extruded aluminum rail with steel linkage, stainless latch bolt and polymer end housings |
|---|---|
| Panneau épaisseur | Approximately 60–70 mm maximum projection from the door face |
| Largeur effective | Approximately 45–60 mm active touch-surface width |
| Longueur maximale | Up to 1200 mm rail length for common single-door openings |
| Acier face épaisseur | 1.5–2.0 mm stainless-steel latch and strike faceplates |
| Densité Core | Approximately 2700 kg/m³ for the aluminum rail material |
| Conductivité thermique | Approximately 160–205 W/(m·K) for the aluminum chassis |
| surface finie | Silver anodized aluminum, charcoal touch surface and restrained red safety insert |
| Type joint | Surface-mounted touch rail linked to a rim latch and aligned frame strike |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
650–1200 mm cut-to-door railMechanical or electrified monitoringStainless or black exterior trimSingle-point rim or vertical-rod latching
Planning a Cleanroom Panic Exit Device specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
