Three-quarter view of a pass box magnetic lock with armature plate and L bracket

Temiz Oda Ekipmanları Yedek Parçaları

Pass Box Manyetik Kilit

A compact fail-safe electromagnetic lock set for retaining an interlocked pass box door during the transfer sequence.

Fail-Safe Electromagnetic Holding
Matched Armature Plate
Compact Chamber Mounting
Two-Core Electrical Lead

Alıntı isteği Browse ürünleri

Ürün tanıtımı

The pass box magnetic lock retains one transfer-chamber door while the opposite door is in use. The set combines a compact aluminum-bodied electromagnet, a matched armature plate, a stainless L-bracket and a short two-core lead for connection to the interlock controller. When correctly aligned, the floating armature seats evenly against the magnetic face and releases when power is removed. Replacement selection must match supply voltage, controller output, available mounting space, door geometry, holding requirement and the fail-safe sequence of the existing pass box.

Ana Özellikler

The matched electromagnet and armature provide repeatable holding across frequent transfer cycles.

A compact rectangular body fits restricted header or side-jamb service spaces.

The stainless L-bracket provides slotted adjustment for face-to-face alignment.

A dedicated red-and-black lead simplifies polarity identification during replacement.

Müşteri Ürün Sorunları

Reliable magnetic holding depends on electrical compatibility and full, parallel contact between the magnet face and armature.

A tilted armature contacts only one edge and substantially reduces holding force.The mounting bracket and armature position are adjusted to provide flat, parallel face contact when the door closes.

The wrong coil voltage can cause weak holding or premature coil failure.The lock voltage and current demand are matched to the pass box controller output before connection.

A rigidly mounted armature may not accommodate small door-alignment changes.The armature is installed with the intended limited compliance so it can seat evenly on the magnetic face.

Residual magnetism or incorrect control logic can delay door release.A compatible low-residual lock and fail-safe control sequence provide prompt release when the output is de-energized.

Tipik uygulamalar

Static pass box door interlocksDynamic pass-through chamber doorsMaterial transfer hatch lock replacementInterlocked cleanroom cabinet doors

Teknik parametreler

Typical construction and dimensional ranges for compact pass box electromagnetic lock sets are shown below.

Temel malzemeler	Laminated electromagnetic steel core with copper coil and matched steel armature plate
Panel kalınlığı	25-45 mm nominal lock-body depth
Effective Width (Etkili Genişlik)	35-70 mm nominal lock-body width
Maksimum uzunluk	Up to 260 mm overall lock-body length
Çelik yüz yüze kalınlığı	3-8 mm nominal armature face thickness
Core Density (Çekirdek Yoğunluğu)	7700-7900 kg/m³ for electromagnetic steel components
Termal İletkenlik	45-55 W/(m·K) for the steel magnetic circuit
Yüzey bitirme	Brushed or anodized silver housing with passivated stainless mounting bracket
Ortak tip	Face-contact electromagnet and armature with slotted L-bracket mounting and two-core lead
Customization (Özelleşme)	Kullanılan uygulama ve çalışma ortamına göre kullanılabilir.

Mevcut Seçenekler

Matched 12 VDC or 24 VDC coilAlternative bracket geometryLonger lead wireDoor-status monitoring contact

Planning a Pass Box Magnetic Lock specification?

Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.

Ekibimizle konuşun