Centrifüjik Çatı Egzoz Fanı
- Weather-Resistant Spun Hood
- Backward-Inclined Centrifugal Wheel
- Downblast Roof Discharge
- Gasketed Curb Mounting
Ürün tanıtımı
The centrifugal roof exhaust fan mounts above a roof opening and draws building air upward through a curb into a backward-inclined wheel. A spun weather hood shields the motor, drive and wheel from rain, while the surrounding windband directs discharge downward toward the roof. The removable hood, ventilated motor compartment and prepunched curb cap provide an accessible outdoor exhaust solution for cleanroom support spaces and general clean-air ventilation.
Ana Özellikler
The backward-inclined centrifugal wheel develops greater static pressure than a simple roof propeller for longer duct systems.
Outside cooling air circulates around the motor compartment instead of relying only on the warm exhaust stream.
A square curb cap with mounting holes and perimeter gasket creates a repeatable sealed connection to the roof curb.
Müşteri Ürün Sorunları
Roof exhaust equipment must resist weather, keep water out of the duct opening and provide enough pressure for the vertical riser below it.
Tipik uygulamalar
Teknik parametreler
Representative construction ranges for a curb-mounted centrifugal downblast roof exhaust fan are provided below.
| Temel malzemeler | Galvanized steel curb base with a backward-inclined steel wheel and corrosion-resistant spun aluminum weather hood |
|---|---|
| Panel kalınlığı | 1.2-2.5 mm typical hood, windband and curb-cap material thickness |
| Effective Width (Etkili Genişlik) | 600-2200 mm nominal roof curb and fan base width |
| Maksimum uzunluk | Up to 2600 mm overall curb-base length according to fan size |
| Çelik yüz yüze kalınlığı | 1.2-2.5 mm galvanized steel curb cap, motor plate and internal support sheet |
| Core Density (Çekirdek Yoğunluğu) | Approximately 7800-7900 kg/m³ for the galvanized steel base and wheel components |
| Termal İletkenlik | Approximately 45-55 W/(m·K) for the galvanized steel structural components |
| Yüzey bitirme | Natural spun aluminum hood with dark green powder-coated base and galvanized internal support surfaces |
| Ortak tip | Bolted square curb cap with perimeter gasket, prepunched mounting holes and removable hood fasteners |
| Customization (Özelleşme) | Kullanılan uygulama ve çalışma ortamına göre kullanılabilir. |
Mevcut Seçenekler
Planning a Centrifugal Roof Exhaust Fan specification?
Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.

İngilizce
Almanca
Arapça
Fransızca
Endonezya dilinde
Japonca
Korece
Malay dilinde
Portekizce
Rusça
İspanyolca
Taylandca
TürkçeCurrent
Vietnamca