Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Accesorios de instalación de sala limpia
Filtro HEPA Clamp por
A stainless swing-bolt HEPA retaining clamp with a broad padded pressure shoe for applying controlled sealing force in room-side filter housings.
- Swing-Bolt Adjustment
- Broad Equi-Bearing Shoe
- Tool-Free Hand Knob
- Padded Stainless Contact
Introducción del producto
The clamp pivots away from the filter edge during change-out and swings back into its operating position before compression is applied with the hand knob. Its broad stainless pressure shoe spreads load across the filter frame, while a thin silicone pad protects the contact face. The two-hole base fixes the mechanism to a terminal housing or holding frame without introducing loose service parts.
Características clave
A broad pressure shoe distributes retention force over more of the filter-frame edge.
The four-lobed knob permits room-side tightening without a separate wrench.
A bonded silicone pad prevents direct metal contact at the loaded surface.
Brushed stainless construction presents smooth exposed surfaces for routine wiping.
Preocupaciones del producto del cliente
HEPA retainers must deliver repeatable compression without damaging the filter frame, creating loose service parts or obstructing room-side replacement.
Narrow fasteners can concentrate force and distort a light-gauge filter frame.The rectangular equi-bearing shoe spreads the applied load over a broad contact area.
Loose nuts and clips are difficult to manage during overhead filter changes.The bolt and pressure arm remain captured by the fixed pivot bracket throughout servicing.
Tool-dependent clamps lengthen room-side replacement and can lead to inconsistent tightening.The large four-lobed hand knob provides direct, visible compression adjustment.
Bare metal pressure faces may scratch coated or anodized filter frames.A bonded black silicone pad separates the stainless shoe from the filter contact surface.
Aplicaciones típicas
Room-side replaceable HEPA terminal housingsGel-seal and gasket-seal filter holding framesCleanroom ceiling filter modulesPharmaceutical exhaust filter housingsLaboratory and healthcare high-efficiency filter banks
Parámetros técnicos
Typical construction and dimensional ranges for a stainless room-side HEPA filter retaining clamp are listed below.
| Materiales Core | 304 stainless-steel pivot bracket, swing bolt, hand knob and pressure shoe with silicone pad |
|---|---|
| Panel de espesor | 0.8-2.0 mm compatible HEPA filter frame wall thickness |
| Ancho efectivo | 40-100 mm pressure-shoe contact width |
| Longitud máxima | Up to 160 mm overall clamp length |
| Acero frente a espesor | 2.0-4.0 mm nominal bracket and shoe thickness |
| Densidad Core | Approximately 8000 kg/m³ for 304 stainless steel |
| Conductividad térmica | Approximately 14-16 W/(m·K) for 304 stainless steel |
| Superficie acabada | Brushed or passivated stainless steel with a matte black silicone contact pad |
| Tipo conjunto | Pivoting captured swing bolt with threaded hand knob and padded equi-bearing shoe |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
304 or 316L stainless-steel constructionM6, M8 or M10 swing-bolt sizeSilicone or EPDM contact padPressure-shoe width matched to the filter frameMounting-hole pattern matched to the terminal housing
Planning a HEPA Filter Clamp specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
