Blue multilayer cleanroom sticky mat shown in complete three-quarter view

Pakaian Bilik Bersih, PPE dan Barangan boleh guna

Mat lengket

Multilayer cleanroom sticky mat with peel-away polyethylene sheets, water-based acrylic tack and numbered corner tabs for routine contamination control.

Peel-away adhesive layers for controlled entrances
Captures particles from footwear and cart wheels
Low-profile polyethylene construction with numbered tabs

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

This Sticky Mat provides a simple floor-level barrier at gowning rooms, airlocks and controlled-area entrances. Each thin polyethylene sheet carries a uniform water-based acrylic adhesive that lifts loose dust from shoe soles, boot covers, casters and cart wheels. When the exposed surface becomes loaded, the operator removes one numbered layer to reveal a fresh tacky sheet without moving the base mat.

Ciri-ciri Utama

Thirty-sheet configurations reduce mat replacement frequency

Numbered corner tabs make remaining-layer checks straightforward

Uniform low-tack surface captures debris without excessive shoe pull

Smooth film supports repeated personnel and light-cart traffic

Floor-side adhesive or an optional frame keeps edges stable in use

Kebimbangan Produk Pelanggan

Entrance contamination control must balance particle pickup, safe passage and predictable maintenance. The mat should remain flat, release footwear cleanly and allow a soiled layer to be removed without spreading captured debris.

Excessive tack may pull at boot covers or create an uncomfortable step.Select medium or high tack according to footwear, wheel load and operating procedure.

Weak edge adhesion can allow the mat to curl under cart traffic.Apply the mat to a clean, dry floor or use a compatible rigid mat frame.

Staff may replace the entire mat before all usable layers are consumed.Use clearly numbered peel tabs to identify the active sheet and remaining stock.

Removing a dirty sheet may transfer captured particles to the floor.Peel the loaded layer slowly toward the center and dispose of it immediately in the designated waste stream.

Permohonan yang biasa

Used at cleanroom and laboratory entrances, gowning-room transition points, airlocks, packaging areas, electronics assembly zones and cart-transfer routes where footwear and wheel-borne particles must be reduced.

Parameter teknikal

The following values describe common peel-off cleanroom sticky-mat constructions. Final dimensions, color, tack grade and packaging can be selected for the entrance layout and traffic pattern.

Bahan Teras	Multilayer low-density polyethylene film with water-based acrylic adhesive
Ketebalan Panel	1.5-2.0 mm for a typical 30-layer mat
Lebar berkesan	450-900 mm
Panjang maksimum	1500 mm
Keluli Menghadapi Ketebalan	0 mm; tiada keluli menghadap digunakan
Ketumpatan teras	910-940 kg/m³ polyethylene film
Kekonduksian Terma	0.33-0.50 W/(m·K), material dependent
Kemasan permukaan	Smooth blue or white peel-away adhesive film with numbered corner tabs
Jenis Bersatu	Laminated peel-off sheet stack with floor-side adhesive backing
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Blue, white, clear or grey filmMedium-tack or high-tack surface30-sheet or 60-sheet stacksFull adhesive backing or adhesive stripsNumbered removable corner tabsCompatible rigid or flexible mat frame

Planning a Sticky Mat specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami