Blue multilayer cleanroom sticky mat shown in complete three-quarter view

クリーンルーム衣料品、 PPE 、消耗品

粘着マット

Multilayer cleanroom sticky mat with peel-away polyethylene sheets, water-based acrylic tack and numbered corner tabs for routine contamination control.

Peel-away adhesive layers for controlled entrances
Captures particles from footwear and cart wheels
Low-profile polyethylene construction with numbered tabs

見積もりリクエスト製品案内

商品紹介

This Sticky Mat provides a simple floor-level barrier at gowning rooms, airlocks and controlled-area entrances. Each thin polyethylene sheet carries a uniform water-based acrylic adhesive that lifts loose dust from shoe soles, boot covers, casters and cart wheels. When the exposed surface becomes loaded, the operator removes one numbered layer to reveal a fresh tacky sheet without moving the base mat.

主要な特徴

Thirty-sheet configurations reduce mat replacement frequency

Numbered corner tabs make remaining-layer checks straightforward

Uniform low-tack surface captures debris without excessive shoe pull

Smooth film supports repeated personnel and light-cart traffic

Floor-side adhesive or an optional frame keeps edges stable in use

お客様の製品に関する懸念事項

Entrance contamination control must balance particle pickup, safe passage and predictable maintenance. The mat should remain flat, release footwear cleanly and allow a soiled layer to be removed without spreading captured debris.

Excessive tack may pull at boot covers or create an uncomfortable step.Select medium or high tack according to footwear, wheel load and operating procedure.

Weak edge adhesion can allow the mat to curl under cart traffic.Apply the mat to a clean, dry floor or use a compatible rigid mat frame.

Staff may replace the entire mat before all usable layers are consumed.Use clearly numbered peel tabs to identify the active sheet and remaining stock.

Removing a dirty sheet may transfer captured particles to the floor.Peel the loaded layer slowly toward the center and dispose of it immediately in the designated waste stream.

典型的な用途

Used at cleanroom and laboratory entrances, gowning-room transition points, airlocks, packaging areas, electronics assembly zones and cart-transfer routes where footwear and wheel-borne particles must be reduced.

技術的なパラメータ

The following values describe common peel-off cleanroom sticky-mat constructions. Final dimensions, color, tack grade and packaging can be selected for the entrance layout and traffic pattern.

コア材料	Multilayer low-density polyethylene film with water-based acrylic adhesive
パネルの厚さ	1.5-2.0 mm for a typical 30-layer mat
有効幅	450-900 mm
最大長さ	1500 mm
鋼鉄の厚さを直面する	0 mm; no steel facing used
コア密度	910-940 kg/m³ polyethylene film
熱伝導率	0.33-0.50 W/(m·K), material dependent
表面仕上げ	Smooth blue or white peel-away adhesive film with numbered corner tabs
ジョイントタイプ	Laminated peel-off sheet stack with floor-side adhesive backing
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Blue, white, clear or grey filmMedium-tack or high-tack surface30-sheet or 60-sheet stacksFull adhesive backing or adhesive stripsNumbered removable corner tabsCompatible rigid or flexible mat frame

Planning a Sticky Mat specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する