Complete stainless steel cleanroom corner guard

Dinding bilik bersih dan sistem siling

Pengawal Corner Cleanroom keluli tahan karat

A formed 304L or 316L stainless steel protector for exposed 90-degree cleanroom wall corners, designed to absorb routine trolley contact and preserve a smooth cleanable junction.

304L or 316L Stainless Steel
90-Degree Impact Protection
Smooth Hygienic Surface
Adhesive or Concealed Fixing

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

Stainless Steel Cleanroom Corner Guards cover vulnerable external wall corners in corridors, material routes and process support areas. The one-piece formed angle spreads light-to-moderate trolley impact across both wall faces instead of allowing the panel edge to dent or split. Satin-polished 304L suits general indoor clean areas, while 316L can be selected for more aggressive wash and chemical exposure. Guards may be bonded to avoid exposed screw heads or mechanically fixed where replacement access is important, with sealed edges maintaining a simple wipeable surface.

Ciri-ciri Utama

A continuous 90-degree fold protects both faces of the wall corner from direct equipment contact.

Two- or three-millimeter stainless plate resists denting better than thin decorative trim.

Satin polishing reduces glare while leaving a smooth surface for routine disinfection.

Adhesive mounting provides an uninterrupted exposed face with no particle-catching fasteners.

Full-height and shorter bumper-height formats protect only the traffic zone that needs reinforcement.

Kebimbangan Produk Pelanggan

Corner protection must resist repeated impact without becoming a sharp edge, a loose cover or a dirt trap beside the wall finish.

Trolleys strike exposed panel corners and open the sealed wall joint.The formed stainless angle spreads impact over two broad wall faces and shields the original edge.

Thin trim dents quickly and leaves an irregular surface that is hard to wipe.A 2–3 mm guard retains a stable flat face under normal corridor contact.

Exposed screw heads collect residue around the fixing points.Adhesive or rear-concealed fixing keeps the cleanroom-facing surface uninterrupted.

Unsealed perimeter gaps allow moisture and soil behind the protector.A continuous compatible sealant bead closes both vertical edges and the guard ends.

Permohonan yang biasa

Pharmaceutical cleanroom corridorsHospital sterile-material transfer cornersFood-processing material routesLaboratory trolley cornersClean manufacturing transfer zones

Parameter teknikal

Common cleanroom stainless steel corner-guard dimensions and finishes are listed below.

Bahan Teras	Solid AISI 304L stainless steel; 316L optional
Ketebalan Panel	2.0 or 3.0 mm formed guard thickness
Lebar berkesan	50 × 50 mm or 75 × 75 mm legs
Panjang maksimum	2500 mm
Keluli Menghadapi Ketebalan	2.0–3.0 mm stainless steel
Ketumpatan teras	N/A — solid stainless steel construction
Kekonduksian Terma	N/A — impact protector, not an insulating panel
Kemasan permukaan	320-grit satin or ASTM No. 4 brushed finish
Jenis Bersatu	Adhesive-bonded or countersunk mechanical fixing with sealed perimeter
Penyesuaian	Terdapat berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi

Pilihan yang boleh didapati

304L or 316L grade50 or 75 mm leg widthAdhesive or pre-drilled fixingFull-height or traffic-height length

Planning a Stainless Steel Cleanroom Corner Guard specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami