Complete single-operator laminar flow clean bench in three-quarter view

Laminar Flow and Containment Equipment 에 대한 리뷰 보기

단일 작업자 계층 흐름 클린 벤치

A compact one-person clean bench sized around a centered working position for routine non-hazardous preparation, inspection and assembly.

Centered One-Person Zone
Compact Laboratory Footprint
Low-Glare Task Lighting
프론트 서비스 액세스

견적 요청 제품 찾아보기

상품 소개

This model narrows the filtered work zone to the natural reach envelope of one seated or standing operator. The centered sash opening, lighting and control panel reduce unnecessary cabinet width while retaining a full stainless work surface. The fan-filter section is accessible from the front or top so the unit can be installed against a wall. Its clean-air zone is intended for non-hazardous product protection in laboratories and small production rooms.

주요 기능

The work opening and light are centered on one operator rather than divided across unused bench width.

A compact base fits between standard laboratory casework modules.

The controller and pressure display remain within easy reach without entering the clean zone.

A one-piece stainless work tray reduces seams beneath small components.

Front-access service panels permit filter and electrical checks where rear clearance is limited.

고객 제품 관심사

Small laboratories need a protected work zone without paying for unused width or losing access to routine service points.

A wide two-person bench wastes valuable laboratory wall space.The cabinet width is matched to a single centered operator position.

Controls mounted inside the work zone interrupt clean handling.External front controls keep operating adjustments outside the protected surface.

Small parts disappear into segmented worktop joints.A one-piece lift-out tray provides a continuous handling surface.

Rear service access is impossible against fixed casework.The fan, filter gauge and electrical components can be reached from the front or top.

일반적인 응용 프로그램

Small-batch device assemblyMicroscope sample setupNon-hazardous media preparationClean component inspection

기술 매개변수

Typical configurable construction ranges for a one-person laminar flow clean bench are listed below.

핵심 재료	SUS304 one-piece work tray with powder-coated steel cabinet and acoustic mineral-fibre lining
패널 두께	25-40 mm double-wall cabinet sections
유효 폭	700-1000 mm clear working width
최대 길이	Up to 2100 mm overall freestanding height
강철 면면 두께	0.8-1.0 mm outer steel; 1.0-1.2 mm SUS304 inner liner
코어 밀도	60-100 kg/m³ acoustic mineral-fibre lining
열전도도 (Thermal Conductivity)	0.036-0.046 W/(m·K) for the acoustic lining
표면 마무리	White epoxy-polyester cabinet finish with brushed stainless work tray
접합 유형	Sealed folded cabinet joints with a lift-out work tray and clamped filter gasket
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Sitting or standing base heightManual front sashIntegrated power socketsLeft or right service utility panel

Planning a Single-Operator Laminar Flow Clean Bench specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.