Complete cleanroom door status sensor pair with brushed stainless faces and aligned magnet

Kontrol Cleanroom dan Sistem Pemantauan Lingkungan

Sensor Status Pintu (Pintu Status Sensor)

A sealed magnetic proximity contact that reports the true open or closed position of a cleanroom door to interlock, pressure and monitoring systems.

Non-Contact Magnetic Sensing
Flush Cleanroom Installation
Sealed Stainless Face
Open-Closed Signal Output

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The cleanroom door status sensor uses a reed or solid-state magnetic element in the frame and a permanent magnet in the moving leaf. Because the two parts do not touch, the device avoids exposed mechanical levers and tolerates frequent door cycles. Flush stainless or smooth polymer housings sit nearly level with the door surfaces for easier wiping. Normally open, normally closed or changeover contacts provide a direct input to airlock interlocks, room pressure controls, alarms and access monitoring.

Fitur utama:

Non-contact switching avoids the wear and debris associated with mechanical limit levers.

Flush or low-profile bodies preserve smooth door and frame surfaces for routine cleaning.

Clearly matched sensor and magnet geometry provides repeatable switching distance.

Dry-contact or solid-state outputs connect directly to common PLC, DDC and interlock inputs.

Kekhawatiran produk pelanggan

Reliable door status depends on alignment, switching gap and cable protection rather than only the electrical contact type.

A door looks closed but the sensor remains open because the magnet is misaligned.Matched flush pockets and alignment marks position the magnet within the specified operating gap.

A protruding limit switch traps residue on the cleanroom frame.A flush non-contact sensor removes exposed actuator arms and horizontal ledges.

Repeated door movement breaks an unprotected cable at the frame.Fixed frame wiring and sealed rear entry keep the cable away from hinges and moving hardware.

The interlock cannot distinguish a cut cable from a closed door.Normally closed or supervised circuits allow open-circuit wiring faults to create a detectable abnormal state.

Aplikasi yang Tipis

Personnel airlock doorsMaterial-transfer airlock doorsCleanroom swing and sliding doorsPass box door monitoring

Parameter teknis

Typical materials and dimensions for a flush cleanroom magnetic door status sensor are shown below.

Bahan inti	Reed or solid-state magnetic element in 304 stainless steel or glass-filled polymer body
Ketebalan Panel (Panel Thickness)	12-25 mm sensor body depth
Efektif lebar	15-30 mm face width
Panjang maksimum	Up to 100 mm sensor body length
Baja menghadap ketebalan	0.8-1.2 mm 304 stainless steel faceplate
Kepadatan inti (core density)	7900-8030 kg/m³ for stainless face components
Konduktivitas Termal (Thermal Conductivity)	14-17 W/(m·K) for 304 stainless steel face
Permukaan selesai	Brushed stainless steel or smooth white polymer with concealed fixing points
Jenis Bersama	Paired recessed sensor and magnet with sealed pigtail or rear screw terminal
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Recessed atau Surface MountNormally open, closed or changeover contactArmored cable leadWide-gap magnet

Planning a Door Status Sensor specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami