Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Cleanroom mur et systèmes de plafond
Cleanroom Wall Base Channel
A galvanized-steel or aluminum floor track that locates modular cleanroom wall panels, transfers base loads and creates a level, sealable interface above the finished floor.
- Level Panel Support
- Direct Floor Anchorage
- Sealed Base Interface
- Demountable Wall Compatible
Introduction de produit
Cleanroom Wall Base Channel is the structural floor track beneath a modular wall run. The channel establishes panel alignment, restrains lateral movement at the base and distributes the wall load to the slab. Lightweight formed-steel versions provide a simple head-and-base track, while adjustable two-part aluminum systems can compensate for floor variation and create a flush recess for resilient or resin flooring. Mechanical anchors secure the lower section and hygienic sealant closes the floor and panel interfaces, leaving the visible room junction ready for coving or a recessed floor return.
Key Features
Mechanical floor anchors transfer base restraint independently of sealant adhesion.
Adjustable aluminum variants compensate for uneven slabs before wall panels are installed.
Recessed configurations accept a flush vinyl or resin floor cove without an exposed ledge.
Demountable wall panels can be removed while the base alignment system remains in place.
Préoccupations du client produit
The base channel must keep the wall level, accommodate the selected floor finish and remain sealed where the partition meets the slab.
An uneven slab causes cumulative panel misalignment higher in the wall.An adjustable base interface or controlled packing establishes a level bearing line before panels are set.
Sealant alone cannot safely restrain movement at the foot of a tall partition.Mechanical anchors secure the channel directly to the structural floor.
A projecting track creates a ledge beside sheet flooring.A recessed base detail receives the floor cove flush with the cleanroom wall face.
Cleaning liquid can enter through an unsealed floor-track joint.Continuous sealant beneath the track and along the panel interface closes both leakage paths.
Les applications typiques
Modular cleanroom wall foundationsPharmaceutical partition basesModular laboratory partition foundationsFood-production hygienic wallsSemiconductor cleanroom enclosures
Paramètres techniques
Typical cleanroom wall base channel construction ranges are shown below.
| Matériaux de base | 6063 aluminum extrusion or formed galvanized/stainless steel |
|---|---|
| Panneau épaisseur | 0.5–2.5 mm channel wall thickness |
| Largeur effective | 50, 75 or 100 mm panel seat width |
| Longueur maximale | 3000–6000 mm per section |
| Acier face épaisseur | 0.5–1.0 mm for formed steel channel; N/A for aluminum version |
| Densité Core | N/A — formed channel has no insulation core |
| Conductivité thermique | N/A — structural floor track, not an insulating panel |
| surface finie | Galvanized, brushed stainless steel, anodized aluminum or powder-coated aluminum |
| Type joint | Mechanically anchored floor track with sealed panel seat and flooring interface |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation |
Options disponibles
Fixed formed channelAdjustable two-part aluminum baseRecess for 2 mm vinyl flooringStainless steel or color-matched finish
Planning a Cleanroom Wall Base Channel specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
