Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Sistemas de distribución de aire para salas limpias
HVAC Duct Wrap Aislamiento
A flexible glass-fiber blanket laminated to a reinforced foil vapor retarder for external thermal and acoustic insulation of metal air ducts.
- Flexible Glass-Fiber Blanket
- Reinforced Foil Vapor Retarder
- Thermal and Acoustic Control
- Fits Rectangular and Round Ducts
Introducción del producto
HVAC duct wrap insulation is installed around the exterior of sheet-metal supply and return ducts to reduce heat gain, heat loss and surface condensation. The resilient glass-fiber blanket conforms to rectangular corners and round profiles, while the factory-applied foil-scrim-kraft or reinforced foil jacket forms the external vapor retarder. Circumferential and longitudinal seams are overlapped and sealed continuously. Installed thickness accounts for compression at duct corners so that the specified thermal resistance is maintained over the complete surface.
Características clave
A reinforced foil facing combines a clean external finish with a low-permeance vapor-control layer.
Multiple densities and thicknesses allow insulation value to be selected without excessive bulk.
The fibrous blanket also absorbs casing-radiated fan and airflow noise from metal duct surfaces.
Preocupaciones del producto del cliente
Duct wrap must remain continuous at corners, hangers and fittings because small gaps in the vapor retarder can produce large areas of condensation.
Cold duct surfaces sweat above the cleanroom ceiling.A continuous insulation layer and sealed low-permeance foil jacket keep the outer surface above the local dew point.
Corner compression reduces the installed thermal resistance.The selected blanket thickness allows for expected compression and uses proper corner wrapping technique.
Staples and hanger penetrations puncture the vapor barrier.Compatible pressure-sensitive foil tape closes seams and all penetrations after fastening.
Unfaced insulation releases fibers into the service void.The factory-laminated facing encloses the exposed blanket surface and is sealed at cut edges.
Aplicaciones típicas
Cold supply-air duct insulationReturn-air thermal controlCleanroom ceiling ductworkAir-handling-unit plenumsRound and rectangular HVAC fittings
Parámetros técnicos
Typical ranges for foil-faced flexible glass-fiber duct wrap are listed below.
| Materiales Core | Resilient glass-fiber blanket bonded with thermosetting resin |
|---|---|
| Panel de espesor | 25–50 mm nominal blanket thickness |
| Ancho efectivo | 1200 mm standard roll width |
| Longitud máxima | 15000–30000 mm standard roll length, depending on thickness |
| Acero frente a espesor | 0.05–0.15 mm reinforced foil laminate facing |
| Densidad Core | 20–48 kg/m³ |
| Conductividad térmica | 0.034–0.043 W/(m·K) at approximately 24°C mean temperature |
| Superficie acabada | Foil-scrim-kraft or reinforced aluminum foil vapor-retarder facing |
| Tipo conjunto | Overlapped wrap seams sealed continuously with pressure-sensitive foil tape |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
25, 38 or 50 mm thickness20–48 kg/m³ nominal densityFSK or all-service foil facingPre-cut widths for standard duct sizes
Planning a HVAC Duct Wrap Insulation specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
