Roll of foil-faced glass-fiber HVAC duct wrap insulation

클린룸 공기 분배 시스템

HVAC 덕트 랩 단열재

A flexible glass-fiber blanket laminated to a reinforced foil vapor retarder for external thermal and acoustic insulation of metal air ducts.

Flexible Glass-Fiber Blanket
Reinforced Foil Vapor Retarder
Thermal and Acoustic Control
Fits Rectangular and Round Ducts

견적 요청 제품 찾아보기

상품 소개

HVAC duct wrap insulation is installed around the exterior of sheet-metal supply and return ducts to reduce heat gain, heat loss and surface condensation. The resilient glass-fiber blanket conforms to rectangular corners and round profiles, while the factory-applied foil-scrim-kraft or reinforced foil jacket forms the external vapor retarder. Circumferential and longitudinal seams are overlapped and sealed continuously. Installed thickness accounts for compression at duct corners so that the specified thermal resistance is maintained over the complete surface.

주요 기능

Flexible glass fibers conform around fittings and transitions without rigid board joints at every change in shape.

A reinforced foil facing combines a clean external finish with a low-permeance vapor-control layer.

Multiple densities and thicknesses allow insulation value to be selected without excessive bulk.

The fibrous blanket also absorbs casing-radiated fan and airflow noise from metal duct surfaces.

고객 제품 관심사

Duct wrap must remain continuous at corners, hangers and fittings because small gaps in the vapor retarder can produce large areas of condensation.

Cold duct surfaces sweat above the cleanroom ceiling.A continuous insulation layer and sealed low-permeance foil jacket keep the outer surface above the local dew point.

Corner compression reduces the installed thermal resistance.The selected blanket thickness allows for expected compression and uses proper corner wrapping technique.

Staples and hanger penetrations puncture the vapor barrier.Compatible pressure-sensitive foil tape closes seams and all penetrations after fastening.

Unfaced insulation releases fibers into the service void.The factory-laminated facing encloses the exposed blanket surface and is sealed at cut edges.

일반적인 응용 프로그램

Cold supply-air duct insulationReturn-air thermal controlCleanroom ceiling ductworkAir-handling-unit plenumsRound and rectangular HVAC fittings

기술 매개변수

Typical ranges for foil-faced flexible glass-fiber duct wrap are listed below.

핵심 재료	Resilient glass-fiber blanket bonded with thermosetting resin
패널 두께	25–50 mm nominal blanket thickness
유효 폭	1200 mm standard roll width
최대 길이	15000–30000 mm standard roll length, depending on thickness
강철 면면 두께	0.05–0.15 mm reinforced foil laminate facing
코어 밀도	20–48 kg/m³
열전도도 (Thermal Conductivity)	0.034–0.043 W/(m·K) at approximately 24°C mean temperature
표면 마무리	Foil-scrim-kraft or reinforced aluminum foil vapor-retarder facing
접합 유형	Overlapped wrap seams sealed continuously with pressure-sensitive foil tape
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

25, 38 or 50 mm thickness20–48 kg/m³ nominal densityFSK or all-service foil facingPre-cut widths for standard duct sizes

Planning a HVAC Duct Wrap Insulation specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.