Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Filtro de aire y filtración química
Filtro de compresión HEPA
A continuous closed-cell elastomer gasket that compresses between the HEPA frame and housing flange to stop perimeter air bypass.
- Closed-Cell Construction
- Controlled Compression
- Continuous Corner Joint
- Multiple Elastomer Grades
Introducción del producto
The compression gasket is bonded to the upstream or downstream face of a HEPA frame and seals against a flat housing flange. Closed-cell polyurethane, neoprene, EPDM or silicone limits air transmission through the foam itself, while the selected hardness lets the gasket recover after clamping. Mitered, vulcanized or moulded endless corners remove gaps at the perimeter. Adhesive backing holds the profile in position during filter installation.
Características clave
Defined thickness and hardness provide a predictable compression window.
Endless or sealed mitered corners eliminate open butt joints.
Pressure-sensitive adhesive keeps the profile aligned on the filter frame.
Preocupaciones del producto del cliente
Perimeter leakage can remain even with an efficient filter if the gasket is porous, misaligned or unevenly compressed.
Open-cell foam allows air to pass through the gasket body.Closed-cell polyurethane, neoprene or silicone forms a substantially less permeable seal.
A butt joint opens at the frame corner.Moulded endless or sealed mitered construction closes the entire perimeter.
Over-tightening permanently flattens the gasket.Specified hardness and clamp travel keep compression within the elastic recovery range.
The strip moves out of position while the filter is inserted.A continuous adhesive backing fixes the gasket to the cleaned frame surface.
Aplicaciones típicas
Gasket-seal HEPA filtersAbsolute filter holding framesSide-access filter housingsCleanroom terminal boxesReplacement filter-bank seals
Parámetros técnicos
Common material and dimensional ranges for HEPA compression gaskets are listed below.
| Materiales Core | Closed-cell polyurethane, neoprene, EPDM or silicone elastomer foam |
|---|---|
| Panel de espesor | 5–12 mm uncompressed gasket thickness |
| Ancho efectivo | 12–25 mm gasket strip width |
| Longitud máxima | Up to 5000 mm continuous coil or custom endless perimeter |
| Acero frente a espesor | 0.05–0.15 mm reinforced pressure-sensitive adhesive carrier where used |
| Densidad Core | 80–250 kg/m³ closed-cell foam density |
| Conductividad térmica | 0.04–0.08 W/(m·K) depending on elastomer grade |
| Superficie acabada | Smooth black, grey or white closed-cell skin with adhesive backing |
| Tipo conjunto | Moulded endless loop or sealed 45-degree miter joints bonded to the filter frame |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
Polyurethane, neoprene, EPDM or siliconeSelf-adhesive strip or moulded loopFlat or hollow profileCustom die-cut frame gasket
Planning a HEPA Filter Compression Gasket specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
