Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Equipos de flujo laminar y contención
Bag-In / Bag-Out Filtro de carcasa
A welded safe-change housing that uses a flexible containment bag over the access collar so loaded filters can be removed and replaced without direct exposure.
- Safe-Change Bagging Collar
- Welded Pressure Housing
- Positive Filter Compression
- Sealed Removable Access Door
Introducción del producto
The BIBO housing encloses a prefilter, HEPA or molecular filter within a welded duct section. A ribbed collar surrounds the service opening and stores a change-out bag behind the access door. During filter replacement, the bag is extended over the operator's hands and the loaded filter, then sealed before removal. A positive clamping mechanism compresses the filter gasket or gel seal, while optional dampers isolate airflow during service.
Características clave
The loaded filter is handled entirely inside the extended change bag.
A positive clamp applies repeatable pressure to the filter seal.
A gasketed access door closes the bag and filter compartment during operation.
Modular sections can combine prefilter, HEPA, damper and test-access stages.
Preocupaciones del producto del cliente
The filter retains concentrated contamination, making replacement a critical exposure point unless the service opening remains enclosed.
Removing the access door exposes the loaded filter.The stored bag extends over the service opening before the filter is handled.
The filter gasket is compressed unevenly.A positive clamping mechanism applies controlled pressure around the frame.
The used bag stub leaves the collar exposed.A new bag captures and seals the retained stub before the next change.
Air continues through the housing during service.Upstream and downstream isolation dampers can close the filter section.
Aplicaciones típicas
Pharmaceutical exhaust filtrationBiosafety laboratory exhaustAnimal facility air systemsHazardous dust collection
Parámetros técnicos
Typical configurable construction ranges for a bag-in/bag-out filter housing are listed below.
| Materiales Core | Welded SUS304 or SUS316L housing with PVC or polyethylene change bag and stainless filter-clamp mechanism |
|---|---|
| Panel de espesor | 40-100 mm housing flange and insulated service sections |
| Ancho efectivo | 305-610 mm nominal filter face width |
| Longitud máxima | Up to 1800 mm multi-stage housing length |
| Acero frente a espesor | 2.0-4.0 mm welded stainless housing wall |
| Densidad Core | Approximately 7900-8000 kg/m³ for austenitic stainless housing material |
| Conductividad térmica | 14-16 W/(m·K) for austenitic stainless steel |
| Superficie acabada | Fine-brushed, passivated or coated stainless housing with smooth ribbed bagging collar |
| Tipo conjunto | Continuously welded duct housing with gasketed access door, ribbed bag collar and positive filter clamp |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
Gasket or gel-seal HEPA frameSingle or multiple filter stagesIsolation dampers and test portsStainless or coated carbon-steel construction
Planning a Bag-In/Bag-Out Filter Housing specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
