Bag-in bag-out HEPA filter housing with sealed access door

Laminar Flow and Containment Equipment 에 대한 리뷰 보기

Bag - In / Bag - Out 필터 하우징

A welded safe-change housing that uses a flexible containment bag over the access collar so loaded filters can be removed and replaced without direct exposure.

Safe-Change Bagging Collar
Welded Pressure Housing
Positive Filter Compression
Sealed Removable Access Door

견적 요청 제품 찾아보기

상품 소개

The BIBO housing encloses a prefilter, HEPA or molecular filter within a welded duct section. A ribbed collar surrounds the service opening and stores a change-out bag behind the access door. During filter replacement, the bag is extended over the operator's hands and the loaded filter, then sealed before removal. A positive clamping mechanism compresses the filter gasket or gel seal, while optional dampers isolate airflow during service.

주요 기능

A ribbed service collar retains the containment bag and security strap.

The loaded filter is handled entirely inside the extended change bag.

A positive clamp applies repeatable pressure to the filter seal.

A gasketed access door closes the bag and filter compartment during operation.

Modular sections can combine prefilter, HEPA, damper and test-access stages.

고객 제품 관심사

The filter retains concentrated contamination, making replacement a critical exposure point unless the service opening remains enclosed.

Removing the access door exposes the loaded filter.The stored bag extends over the service opening before the filter is handled.

The filter gasket is compressed unevenly.A positive clamping mechanism applies controlled pressure around the frame.

The used bag stub leaves the collar exposed.A new bag captures and seals the retained stub before the next change.

Air continues through the housing during service.Upstream and downstream isolation dampers can close the filter section.

일반적인 응용 프로그램

Pharmaceutical exhaust filtrationBiosafety laboratory exhaustAnimal facility air systemsHazardous dust collection

기술 매개변수

Typical configurable construction ranges for a bag-in/bag-out filter housing are listed below.

핵심 재료	Welded SUS304 or SUS316L housing with PVC or polyethylene change bag and stainless filter-clamp mechanism
패널 두께	40-100 mm housing flange and insulated service sections
유효 폭	305-610 mm nominal filter face width
최대 길이	Up to 1800 mm multi-stage housing length
강철 면면 두께	2.0-4.0 mm welded stainless housing wall
코어 밀도	Approximately 7900-8000 kg/m³ for austenitic stainless housing material
열전도도 (Thermal Conductivity)	14 - 16 W / (m · K) 오스테나이트 스테인레스 스틸
표면 마무리	Fine-brushed, passivated or coated stainless housing with smooth ribbed bagging collar
접합 유형	Continuously welded duct housing with gasketed access door, ribbed bag collar and positive filter clamp
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Gasket or gel-seal HEPA frameSingle or multiple filter stagesIsolation dampers and test portsStainless or coated carbon-steel construction

Planning a Bag-In/Bag-Out Filter Housing specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.