Stainless steel cleanroom floor cover strip with countersunk fixing holes

Sistem Lantai Bilik Bersih

Keluli tahan karat Cleanroom Lantai Penutup Jalur

A slim stainless steel bridge strip that covers butt joints between adjacent floor finishes and shields their exposed edges at cleanroom thresholds and transitions.

30–50 mm Cover Widths
Low-Profile Transition
Protected Flooring Edges
Countersunk Fixing

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The stainless steel cleanroom floor cover strip spans the meeting line between floor coverings of the same or slightly different height. Its shallow curved section hides small cut-edge irregularities and prevents wheels or footwear from catching the exposed material edge. Side-drilled countersunk holes keep fastener heads level with the polished or matt surface, while a 2.7 metre standard length reduces unnecessary joins across common door openings. Unlike a movement joint, this strip is intended to bridge and protect a stable finish transition rather than absorb structural displacement.

Ciri-ciri Utama

The solid stainless steel face resists routine wear at doorways and frequently crossed flooring seams.

A shallow curved bridge smooths minor height differences without creating a bulky threshold ramp.

Countersunk holes receive flush fixings that do not project into the wheel path.

Several widths cover different edge tolerances while keeping the visible strip proportionate to the opening.

Kebimbangan Produk Pelanggan

A stable floor-covering joint still requires edge protection when cut lines, slight height differences and repeated doorway traffic meet in one location.

Cart wheels catch a small raised edge where two floor finishes meet.The curved cover strip bridges the join and provides a continuous metal crossing surface.

Cleaning and traffic gradually fray or chip an exposed vinyl or resin edge.The stainless steel face shields both finish margins from direct contact.

Proud screw heads create dirt-catching points along a threshold plate.Side-drilled countersunk holes allow compatible fasteners to finish flush with the strip.

A short trim requires multiple visible joins across a wide doorway.The 2700 mm standard length can span most single and double cleanroom openings in one piece.

Permohonan yang biasa

Cleanroom door thresholdsVinyl-to-resin floor transitionsStable repaired flooring seamsGowning room entrancesLaboratory corridor finish changes

Parameter teknikal

Representative dimensions and materials for a stainless steel floor-covering protection strip are listed below.

Bahan Teras	Solid austenitic stainless steel cover strip for interior flooring transitions
Ketebalan Panel	1.0–2.0 mm solid strip thickness, depending on cover width
Lebar berkesan	30–50 mm exposed bridge width
Panjang maksimum	2700 mm standard straight strip length
Keluli Menghadapi Ketebalan	1.0–2.0 mm full-thickness stainless steel facing
Ketumpatan teras	About 7900 kg/m³ for the solid austenitic stainless steel strip
Kekonduksian Terma	Approximately 14–21 W/(m·K) for common austenitic stainless steel grades
Kemasan permukaan	Polished or matt stainless steel with deburred longitudinal edges
Jenis Bersatu	Side-drilled and countersunk mechanically fixed bridge over a stable flooring butt joint
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

30, 40 or 50 mm cover widthPolished or matt stainless steel finishPre-drilled or undrilled supplyCut length and custom countersunk hole spacing

Planning a Stainless Steel Cleanroom Floor Cover Strip specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami