Stainless steel cleanroom floor cover strip with countersunk fixing holes

클린룸 바닥 시스템

스테인레스 스틸 클린룸 바닥 덮개 스트립

A slim stainless steel bridge strip that covers butt joints between adjacent floor finishes and shields their exposed edges at cleanroom thresholds and transitions.

30–50 mm Cover Widths
Low-Profile Transition
Protected Flooring Edges
Countersunk Fixing

견적 요청 제품 찾아보기

상품 소개

The stainless steel cleanroom floor cover strip spans the meeting line between floor coverings of the same or slightly different height. Its shallow curved section hides small cut-edge irregularities and prevents wheels or footwear from catching the exposed material edge. Side-drilled countersunk holes keep fastener heads level with the polished or matt surface, while a 2.7 metre standard length reduces unnecessary joins across common door openings. Unlike a movement joint, this strip is intended to bridge and protect a stable finish transition rather than absorb structural displacement.

주요 기능

The solid stainless steel face resists routine wear at doorways and frequently crossed flooring seams.

A shallow curved bridge smooths minor height differences without creating a bulky threshold ramp.

Countersunk holes receive flush fixings that do not project into the wheel path.

Several widths cover different edge tolerances while keeping the visible strip proportionate to the opening.

고객 제품 관심사

A stable floor-covering joint still requires edge protection when cut lines, slight height differences and repeated doorway traffic meet in one location.

Cart wheels catch a small raised edge where two floor finishes meet.The curved cover strip bridges the join and provides a continuous metal crossing surface.

Cleaning and traffic gradually fray or chip an exposed vinyl or resin edge.The stainless steel face shields both finish margins from direct contact.

Proud screw heads create dirt-catching points along a threshold plate.Side-drilled countersunk holes allow compatible fasteners to finish flush with the strip.

A short trim requires multiple visible joins across a wide doorway.The 2700 mm standard length can span most single and double cleanroom openings in one piece.

일반적인 응용 프로그램

Cleanroom door thresholdsVinyl-to-resin floor transitionsStable repaired flooring seamsGowning room entrancesLaboratory corridor finish changes

기술 매개변수

Representative dimensions and materials for a stainless steel floor-covering protection strip are listed below.

핵심 재료	Solid austenitic stainless steel cover strip for interior flooring transitions
패널 두께	1.0–2.0 mm solid strip thickness, depending on cover width
유효 폭	30–50 mm exposed bridge width
최대 길이	2700 mm standard straight strip length
강철 면면 두께	1.0–2.0 mm full-thickness stainless steel facing
코어 밀도	About 7900 kg/m³ for the solid austenitic stainless steel strip
열전도도 (Thermal Conductivity)	Approximately 14–21 W/(m·K) for common austenitic stainless steel grades
표면 마무리	Polished or matt stainless steel with deburred longitudinal edges
접합 유형	Side-drilled and countersunk mechanically fixed bridge over a stable flooring butt joint
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

30, 40 or 50 mm cover widthPolished or matt stainless steel finishPre-drilled or undrilled supplyCut length and custom countersunk hole spacing

Planning a Stainless Steel Cleanroom Floor Cover Strip specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.