Three-quarter view of a flat panel pre-filter for HVAC intake-air filtration

Penapis udara dan penapisan kimia

Panel rata pra-penapis

An economical flat-media first-stage filter that arrests lint, fibers and coarse dust before they load coils or higher-efficiency filters.

Progressive-Density Media
Low Initial Resistance
Rigid Bonded Frame
First-Stage Equipment Protection

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The flat panel pre-filter uses a flat pad of progressively dense glass or polyester fiber bonded into a moisture-resistant frame. Open fibers on the entering-air side accept large debris, while the denser downstream layer retains smaller coarse particles through the pad depth. Thermoplastic bonding around the perimeter closes bypass paths and keeps the media seated during normal fan cycling. The shallow construction fits standard prefilter tracks where low resistance and simple replacement are more important than fine-particle efficiency.

Ciri-ciri Utama

A progressive fiber gradient distributes dust through the media depth instead of forming an immediate surface cake.

The shallow flat pad adds little resistance at normal air-handler face velocities.

Perimeter bonding prevents the media from lifting away from the frame as airflow changes.

A one-piece moisture-resistant frame keeps corners square during storage, handling and installation.

Kebimbangan Produk Pelanggan

A primary filter must capture bulky contamination without consuming the pressure budget needed by downstream fine filters.

Lint and insects accumulate on cooling coils and block heat-transfer surfaces.The open upstream fiber layer intercepts large debris before it reaches the coil face.

A coarse filter with excessive resistance reduces supply airflow from small fans.A shallow low-density media pad preserves a broad open area and low clean-filter pressure drop.

Media edges lift from weak frames and let unfiltered air bypass the pad.Continuous thermoplastic perimeter bonding secures the pad to the frame on all four sides.

Frequent handling crushes corners and prevents the panel from sealing in its track.A rigid interlocking frame and reinforced corners maintain the specified face dimensions.

Permohonan yang biasa

Fresh-air intake pre-filtrationAir-handling unit coil protectionFan-coil return-air sectionsPrefilters ahead of bag or compact filtersLight industrial ventilation systems

Parameter teknikal

Typical construction ranges for a disposable flat panel pre-filter are listed below.

Bahan Teras	Progressive-density glass fiber or bonded polyester coarse-filter pad
Ketebalan Panel	25 or 50 mm nominal filter depth
Lebar berkesan	290-610 mm standard face width
Panjang maksimum	Up to 610 mm standard face length; larger custom panels may use intermediate support
Keluli Menghadapi Ketebalan	0.30-0.45 mm optional galvanized-steel downstream support grid
Ketumpatan teras	Approximately 25-40 kg/m³ nominal fiber-pad bulk density
Kekonduksian Terma	Approximately 0.035-0.045 W/(m·K) for the dry fiber pad
Kemasan permukaan	Natural white or tinted adhesive-treated fiber media in a moisture-resistant kraft frame
Jenis Bersatu	Flat media pad continuously bonded into a one-piece interlocking panel frame
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Glass-fiber or polyester media25 mm or 50 mm depthMoisture-resistant board or metal frameDownstream wire support grid

Planning a Flat Panel Pre-Filter specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami