Three-quarter view of a flat panel pre-filter for HVAC intake-air filtration

공기 필터 및 화학 여과

평면 패널 사전 필터

An economical flat-media first-stage filter that arrests lint, fibers and coarse dust before they load coils or higher-efficiency filters.

Progressive-Density Media
낮은 초기 저항
Rigid Bonded Frame
First-Stage Equipment Protection

견적 요청 제품 찾아보기

상품 소개

The flat panel pre-filter uses a flat pad of progressively dense glass or polyester fiber bonded into a moisture-resistant frame. Open fibers on the entering-air side accept large debris, while the denser downstream layer retains smaller coarse particles through the pad depth. Thermoplastic bonding around the perimeter closes bypass paths and keeps the media seated during normal fan cycling. The shallow construction fits standard prefilter tracks where low resistance and simple replacement are more important than fine-particle efficiency.

주요 기능

A progressive fiber gradient distributes dust through the media depth instead of forming an immediate surface cake.

The shallow flat pad adds little resistance at normal air-handler face velocities.

Perimeter bonding prevents the media from lifting away from the frame as airflow changes.

A one-piece moisture-resistant frame keeps corners square during storage, handling and installation.

고객 제품 관심사

A primary filter must capture bulky contamination without consuming the pressure budget needed by downstream fine filters.

Lint and insects accumulate on cooling coils and block heat-transfer surfaces.The open upstream fiber layer intercepts large debris before it reaches the coil face.

A coarse filter with excessive resistance reduces supply airflow from small fans.A shallow low-density media pad preserves a broad open area and low clean-filter pressure drop.

Media edges lift from weak frames and let unfiltered air bypass the pad.Continuous thermoplastic perimeter bonding secures the pad to the frame on all four sides.

Frequent handling crushes corners and prevents the panel from sealing in its track.A rigid interlocking frame and reinforced corners maintain the specified face dimensions.

일반적인 응용 프로그램

Fresh-air intake pre-filtrationAir-handling unit coil protectionFan-coil return-air sectionsPrefilters ahead of bag or compact filtersLight industrial ventilation systems

기술 매개변수

Typical construction ranges for a disposable flat panel pre-filter are listed below.

핵심 재료	Progressive-density glass fiber or bonded polyester coarse-filter pad
패널 두께	25 or 50 mm nominal filter depth
유효 폭	290-610 mm standard face width
최대 길이	Up to 610 mm standard face length; larger custom panels may use intermediate support
강철 면면 두께	0.30-0.45 mm optional galvanized-steel downstream support grid
코어 밀도	Approximately 25-40 kg/m³ nominal fiber-pad bulk density
열전도도 (Thermal Conductivity)	Approximately 0.035-0.045 W/(m·K) for the dry fiber pad
표면 마무리	Natural white or tinted adhesive-treated fiber media in a moisture-resistant kraft frame
접합 유형	Flat media pad continuously bonded into a one-piece interlocking panel frame
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Glass-fiber or polyester media25 mm or 50 mm depthMoisture-resistant board or metal frameDownstream wire support grid

Planning a Flat Panel Pre-Filter specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.