Cleanroom door interlock controller with enclosed power and logic modules

Pintu Bilik Bersih, Windows dan Sistem Interlock

Kawalan Interlock Pintu Bilik Bersih

A central low-voltage controller for cleanroom airlocks, coordinating door-position inputs, electric locks, request devices, status indicators, alarms and emergency release functions.

Configurable Door Logic
Labeled Lock and Sensor I/O
Alarm and Emergency Inputs
Access-Control Integration

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The cleanroom door interlock controller is the logic hub behind a personnel or material airlock. It reads each door-position contact, determines whether another opening request is permitted and controls the corresponding electromagnetic lock or electric strike. A serviceable enclosure contains the power supply, protected output circuits, labeled terminals and programmable logic. Interface contacts can exchange status or release commands with access control, fire alarm and building-management systems without placing exposed electronics in the cleanroom doorway.

Ciri-ciri Utama

Dedicated inputs distinguish door-closed feedback, opening requests and emergency release commands.

Protected lock outputs support common fail-safe or fail-secure electric-lock arrangements.

Adjustable door-open and air-purge delays accommodate different airlock operating sequences.

Dry-contact interfaces allow coordinated signals with access control, fire alarm and BMS equipment.

Kebimbangan Produk Pelanggan

A controller must make door state visible, release locks safely and avoid ambiguous field wiring while remaining flexible enough for different airlock sequences.

A controller releases a second door because it cannot confirm that the first door is fully closed.Independent door-position inputs are evaluated before every release output is enabled.

Unlabeled field terminals make service faults difficult to isolate.Grouped and clearly identified inputs, lock outputs and auxiliary contacts simplify tracing and replacement.

A rigid sequence cannot accommodate purge time or emergency egress requirements.Configurable timers and dedicated emergency/fire inputs separate normal operating logic from safety release behavior.

Permohonan yang biasa

Personnel airlocksMaterial airlocksCleanroom gowning suitesLaboratory containment entrances

Parameter teknikal

Typical controller enclosure and low-voltage interface ranges are listed below.

Bahan Teras	Industrial control PCB, protected relay outputs and regulated low-voltage power supply in a service enclosure
Ketebalan Panel	80–130 mm enclosure depth
Lebar berkesan	200–300 mm enclosure width
Panjang maksimum	350 mm enclosure height
Keluli Menghadapi Ketebalan	1.0–1.5 mm powder-coated steel enclosure; polycarbonate enclosure optional
Ketumpatan teras	Approximately 1800–1920 kg/m³ for the glass-reinforced PCB laminate
Kekonduksian Terma	Approximately 0.4–0.7 W/(m·K) for the PCB laminate used inside the controller
Kemasan permukaan	Powder-coated steel or smooth sealed polycarbonate enclosure with labeled internal terminals
Jenis Bersatu	DIN-rail and PCB terminal connections for door contacts, locks, request buttons and auxiliary dry contacts
Penyesuaian	Terdapat berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi

Pilihan yang boleh didapati

12 or 24 VDC lock circuitsFail-safe or fail-secure logicDoor-open alarm and purge timerFire alarm, BMS and access-control interfaces

Planning a Cleanroom Door Interlock Controller specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami