Three-quarter view of an EPDM pipe penetration seal with stainless plates

클린룸 설치 액세서리

파이프 관통 씰

A bolted EPDM compression seal that closes the annular gap between a service pipe and a cleanroom wall sleeve.

Radial EPDM Compression
Stainless Pressure Plates
Six-Point Bolt Loading
Replaceable Mechanical Seal

견적 요청 제품 찾아보기

상품 소개

The pipe penetration seal uses a thick annular EPDM element between two circular stainless pressure plates. Even tightening of six perimeter fasteners compresses the elastomer axially and drives it radially against the service pipe and sleeve bore. The removable assembly creates a controlled, cleanable transition without permanently bonding the pipe into the wall opening.

주요 기능

Axial plate compression expands the EPDM ring radially against both sealing surfaces.

Six evenly spaced fasteners distribute loading around the circumference.

Stainless plates provide smooth exposed faces suitable for controlled interiors.

A mechanical assembly can be inspected, retightened or replaced when service arrangements change.

고객 제품 관심사

The annular gap around a pipe can leak air, collect residue and transmit vibration unless it is closed with a compatible flexible seal.

Irregular bolt loading leaves local leakage paths around the pipe.Six equally spaced fasteners apply controlled circumferential compression.

Rigid grout cannot accommodate pipe movement or vibration.The EPDM annulus retains elastic contact with the pipe and sleeve surfaces.

Permanent sealants complicate later pipe replacement.The bolted pressure-plate assembly can be released and removed for service.

Rough exposed filler is difficult to wipe clean.Smooth stainless face plates create defined, accessible room-side surfaces.

일반적인 응용 프로그램

Cleanroom process-pipe penetrationsUtility line wall sleevesConduit and service passagesHygienic partition transitionsEquipment service connections

기술 매개변수

Typical construction ranges for a stainless-plate EPDM pipe penetration compression seal are listed below.

핵심 재료	Black EPDM annular seal with 304 or 316 stainless compression plates and fasteners
패널 두께	40-200 mm compatible wall and sleeve assembly thickness
유효 폭	20-250 mm pipe opening diameter
최대 길이	Up to 350 mm overall seal outside diameter
강철 면면 두께	2.00-6.00 mm stainless compression-plate thickness
코어 밀도	Approximately 1100-1300 kg/m³ for EPDM elastomer
열전도도 (Thermal Conductivity)	Approximately 0.20-0.30 W/(m·K) for EPDM
표면 마무리	Black molded EPDM with brushed or satin stainless pressure plates
접합 유형	Bolted axial compression producing radial pipe-to-sleeve sealing
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

EPDM or silicone elastomer304 or 316 stainless hardwareSplit-ring retrofit constructionCustom pipe and sleeve diameters

Planning a Pipe Penetration Seal specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.