Blue chilled-water circulation pump with motor on common base

클린룸 HVAC 및 공기 처리 장비

냉각수 순환 펌프

A base-mounted end-suction centrifugal pump that circulates chilled water between the chiller, air-handling coils and process cooling branches.

Stable Hydronic Flow
Back-Pull-Out Service
Variable-Speed Ready
Rigid Base Alignment

견적 요청 제품 찾아보기

상품 소개

The chilled-water pump couples a single-stage cast-iron volute to a high-efficiency motor on a common baseplate. Its end-suction geometry provides a straight inlet path, while the top discharge fits conventional mechanical-room headers. A guarded flexible coupling accommodates minor alignment tolerance and allows the rotating assembly to be serviced without disturbing connected pipework when a back-pull-out arrangement is selected.

주요 기능

A smoothly contoured volute converts impeller velocity into useful system pressure with limited hydraulic loss.

Common-base motor and pump alignment reduces vibration transmitted to cleanroom piping networks.

Mechanical-seal and coupling access supports planned maintenance without cutting the main suction and discharge lines.

Variable-frequency drive compatibility follows two-way valve demand and reduces unnecessary throttling energy.

고객 제품 관심사

Chilled-water service requires correct flow, low vibration and reliable seals across continuously changing cooling demand.

Oversized constant-speed pumps waste energy against throttled valves.A variable-speed motor adjusts differential pressure and flow to actual coil demand.

Poor suction conditions create cavitation noise and impeller damage.A straight end-suction inlet and correctly selected NPSH margin support stable flow into the eye.

Motor-pump misalignment shortens bearing and seal life.A machined common base and guarded flexible coupling preserve shaft alignment.

Seal replacement causes extended system shutdown.Back-pull-out access removes the rotating assembly while the volute remains connected to the piping.

일반적인 응용 프로그램

Primary chilled-water loopsSecondary variable-flow distributionCleanroom AHU coil circuitsProcess-equipment cooling waterLow-temperature laboratory systems

기술 매개변수

Typical mechanical construction for a cleanroom chilled-water pump set is summarized below.

핵심 재료	Cast-iron volute with stainless steel or bronze impeller and steel shaft
패널 두께	8-16 mm fabricated steel baseplate thickness
유효 폭	350-900 mm typical pump-set width
최대 길이	Up to 2400 mm including motor and coupling
강철 면면 두께	1.5-2.5 mm removable coupling-guard sheet
코어 밀도	Approximately 7000-7300 kg/m³ for cast-iron volute material
열전도도 (Thermal Conductivity)	Approximately 45-55 W/(m·K) for cast-iron wetted casing
표면 마무리	Blue epoxy coating on cast iron with painted steel base
접합 유형	Flanged suction/discharge, flexible shaft coupling and bolted base mounts
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Stainless steel or bronze impellerMechanical-seal material combinationsVariable-frequency drive and differential-pressure sensorSingle duty, duty-standby or twin-pump skid

Planning a Chilled-Water Circulation Pump specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.