Three-quarter view of a square pale-blue HEPA gel seal channel

Aksesoris Instalasi Cleanroom

HEPA Gel Seal Seal

A continuous pale-blue silicone gel seal retained in an anodized aluminum channel for knife-edge HEPA filter interfaces in cleanroom terminal housings.

Continuous Gel Channel
Knife-Edge Interface
Low-Outgassing Silicone
Room-Side Serviceability

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The seal uses a continuous U-shaped aluminum channel filled with compliant silicone gel around all four sides of the filter perimeter. When the housing knife edge enters the gel, the material flows around minor surface irregularities to form a continuous interface without relying on high gasket compression. The gel remains captive in the channel during room-side filter removal and replacement.

Fitur utama:

A continuous four-sided channel eliminates open ends along the active sealing perimeter.

Compliant silicone gel conforms around the mating knife edge and small surface deviations.

The anodized aluminum carrier controls gel position and protects the seal during handling.

Pale-blue coloration provides visible contrast for inspection of the gel surface.

The channel profile supports repeated room-side filter change procedures.

Kekhawatiran produk pelanggan

Terminal HEPA interfaces must remain continuous around the full perimeter while accommodating small housing tolerances and repeated filter change-out.

Rigid sealing surfaces can leave bypass paths where the mating frame is slightly uneven.The compliant gel flows around the entering knife edge and conforms to minor geometric variation.

High gasket compression can make heavy ceiling filters difficult to seat consistently.Knife-edge immersion creates the seal without requiring the same level of bulk gasket compression.

Loose sealing compound can migrate or become contaminated during filter handling.The U-shaped aluminum carrier retains the gel around the complete perimeter.

Seal damage may be hard to see before a replacement filter is installed.The pale-blue gel contrasts with the silver channel for straightforward visual inspection.

Aplikasi yang Tipis

Room-side replaceable HEPA terminal filtersCleanroom ceiling filter housingsPharmaceutical supply and exhaust terminalsLaboratory containment filter interfacesMicroelectronics and healthcare high-efficiency filtration

Parameter teknis

Typical material and dimensional ranges for an aluminum-channel HEPA silicone gel seal are listed below.

Bahan inti	Low-outgassing silicone gel retained in an anodized aluminum U-channel
Ketebalan Panel (Panel Thickness)	1.0-1.5 mm nominal aluminum channel wall thickness
Efektif lebar	10-25 mm active gel channel width
Panjang maksimum	Up to 1220 mm per continuous frame side
Baja menghadap ketebalan	0.8-1.2 mm equivalent metal carrier facing thickness
Kepadatan inti (core density)	Approximately 950-1050 kg/m³ for cured silicone gel
Konduktivitas Termal (Thermal Conductivity)	Approximately 0.15-0.25 W/(m·K) for silicone gel
Permukaan selesai	Clear or natural anodized aluminum with translucent pale-blue silicone gel
Jenis Bersama	Continuous four-sided gel channel for immersion by a mating housing knife edge
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Silicone or polyurethane gel formulationPale blue or clear gel colorCustom square or rectangular perimeter dimensionsChannel depth matched to the housing knife edgeAluminum carrier finish matched to the filter frame

Planning a HEPA Gel Seal specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami