Three-quarter view of a stainless steel blind rivet for cleanroom assembly

클린룸 설치 액세서리

스테인리스 스틸 리벳

A stainless steel blind rivet that forms a permanent mechanical joint where cleanroom sheet-metal components are accessible from only one side.

One-Side Installation
Stainless Construction
Controlled Clamping
Compact Flush Head

견적 요청 제품 찾아보기

상품 소개

This blind rivet combines a tubular stainless sleeve, low-profile flange head and central pull mandrel. A compatible riveting tool draws the mandrel to expand the concealed end of the sleeve, clamping overlapping sheet-metal parts without rear access. The compact head suits trims, closures and light-gauge cleanroom fabrications where exposed fasteners should remain neat and easy to wipe.

주요 기능

Blind installation secures overlapping components when the rear face cannot be reached.

Stainless construction supports corrosion resistance in routinely cleaned interior environments.

The formed rear bulb spreads clamping force across thin sheet instead of relying on cut threads.

A low domed head creates a compact exposed profile on trims and closures.

고객 제품 관심사

Thin cleanroom sheet-metal parts often require a permanent joint even when finished panels block access to the rear surface.

Installers cannot hold a nut behind a closed panel or trim cavity.Blind-rivet setting forms the concealed retaining bulb entirely from the accessible face.

Ordinary carbon-steel fasteners can stain or corrode after repeated cleaning.A stainless sleeve and compatible mandrel provide improved corrosion resistance for controlled interiors.

Oversized fasteners distort light-gauge sheet around the fixing point.Correct rivet diameter, grip range and drilled-hole tolerance distribute clamp load without excessive tightening torque.

Protruding hardware creates an untidy, difficult-to-wipe surface.The compact domed flange leaves a smooth exposed head after the mandrel breaks.

일반적인 응용 프로그램

Cleanroom trim fasteningSheet-metal enclosure assemblyPanel closure stripsDoor and window frame accessoriesLight-duty duct and service covers

기술 매개변수

Typical construction and compatibility ranges for stainless blind rivets used with cleanroom sheet-metal accessories are listed below.

핵심 재료	A2 or A4 stainless-steel sleeve with stainless pull mandrel
패널 두께	0.8-6.0 mm combined material grip range
유효 폭	3.2-6.4 mm nominal rivet diameter
최대 길이	Up to 25 mm rivet body length
강철 면면 두께	0.30-0.80 mm tubular sleeve wall
코어 밀도	Approximately 7900-8000 kg/m³ for stainless steel
열전도도 (Thermal Conductivity)	Approximately 14-17 W/(m·K) for austenitic stainless steel
표면 마무리	Natural passivated silver stainless-steel finish
접합 유형	Blind mechanical fastening with mandrel-expanded sleeve and domed flange head
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

A2 or A4 stainless gradeStandard or large flange headMultiple diameters and grip rangesSealed-end body for reduced leakage paths

Planning a Stainless Steel Rivet specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.