폭발 방지 팬 필터 유닛
- Non-Sparking Blower Assembly
- Cast-Metal Motor Enclosure
- Sealed Junction Box and Conduit
- Bonded Grounding Path
상품 소개
The explosion-proof fan filter unit isolates electrical and rotating ignition sources with a heavy cast-metal motor enclosure, bolted junction box, rigid conduit and sealed fittings. A non-sparking impeller moves air through the prefilter and final filter, while a dedicated bonding strap connects the casing and metal prefilter frame to ground. The reinforced stainless or rolled-steel plenum supports the heavier drive assembly and uses a baffled diffuser to distribute airflow. Electrical voltage, enclosure construction and hazardous-area suitability are selected to match the intended process environment.
주요 기능
Bolted cast-metal junction hardware contains electrical terminations and connects through rigid sealed conduit.
A visible bonding strap links removable metal filter components to the grounded FFU casing.
The reinforced frame carries the concentrated motor load without distorting the filter seal or ceiling flange.
고객 제품 관심사
A hazardous clean area must control particles while preventing the fan, wiring and removable prefilter from introducing an avoidable ignition source.
일반적인 응용 프로그램
기술 매개변수
Typical construction ranges for a hazardous-duty explosion-proof fan filter unit are listed below.
| 핵심 재료 | Reinforced stainless or powder-coated steel plenum, non-sparking centrifugal impeller, cast-metal motor enclosure and micro-glass HEPA or ULPA filter |
|---|---|
| 패널 두께 | 450-550 mm overall module depth including the hazardous-duty motor assembly |
| 유효 폭 | 575-610 mm nominal module width |
| 최대 길이 | Up to 1220 mm standard module length |
| 강철 면면 두께 | 1.2-2.0 mm reinforced stainless or powder-coated rolled-steel housing sheet |
| 코어 밀도 | Approximately 90-120 kg/m³ nominal compacted density of the final-filter pack used in the explosion-protected FFU assembly |
| 열전도도 (Thermal Conductivity) | Approximately 0.035-0.043 W/(m·K) for the dry final-filter pack used in the explosion-protected FFU assembly |
| 표면 마무리 | Brushed stainless steel or chemically resistant powder coating with grounded bare-metal bonding points |
| 접합 유형 | Reinforced ceiling flange with bonded perimeter gasket and room-side gel-seal or compression-seal filter interface |
| 사용자 정의 | 의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다. |
사용 가능한 옵션
Planning a Explosion-Proof Fan Filter Unit specification?
치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

영어
독일어
아랍어
프랑스어
인도네시아어
일본어
한국어현재 Current
말레이어
포르투갈어
러시아어
스페인어
태국어
터키어
베트남어