클린룸 설치 액세서리

EPDM 가스켓

A resilient black EPDM compression gasket formed as a closed loop or cut profile for sealing cleanroom frames, panels and service covers.

Weather-Resistant EPDM
Controlled Compression Recovery
Closed-Loop Frame Seal
Profile-Specific Fit

견적 요청 제품 찾아보기

상품 소개

The EPDM gasket is extruded from black ethylene propylene diene rubber as a hollow or cellular profile with raised sealing ribs. Cut lengths can be joined into rectangular loops for doors, access covers and equipment frames, while continuous profiles suit straight panel interfaces. The compound retains elastic recovery under repeated compression and offers practical resistance to water, ozone, weathering and many dilute cleaning solutions encountered around controlled environments.

주요 기능

Raised sealing ribs concentrate contact pressure along the mating frame surface.

A hollow compressible section accommodates hardware tolerances without excessive closing force.

EPDM resists ozone, moisture and outdoor weathering better than many general-purpose rubbers.

Vulcanized or bonded corner joints create a continuous loop around rectangular openings.

고객 제품 관심사

A frame gasket must close variable gaps repeatedly while avoiding excessive latch force or permanent compression set.

A solid oversized gasket makes doors difficult to close and overloads latches.The hollow profile compresses progressively so sealing pressure develops without an abrupt closing load.

Flattened rubber fails to recover after long periods under compression.An EPDM compound and section geometry are selected for resilient recovery at the intended squeeze.

Open corner joints become leakage paths around access frames.Factory-vulcanized or carefully bonded mitred corners maintain a continuous closed loop.

Ozone and cleaning moisture crack unsuitable elastomers.Weather-resistant EPDM provides durable service where oil exposure is not the primary requirement.

일반적인 응용 프로그램

Cleanroom door and hatch framesAccess-panel perimeter sealsAir-handling equipment coversPanel-to-frame compression jointsUtility enclosure doors

기술 매개변수

Typical construction ranges for a custom extruded EPDM compression gasket are shown below.

핵심 재료	Black EPDM elastomer in hollow, cellular or compact extruded profile
패널 두께	3-20 mm uncompressed gasket profile height
유효 폭	6-40 mm profile contact width
최대 길이	Up to 50000 mm continuous extrusion or custom closed-loop perimeter
강철 면면 두께	0.50-2.00 mm compatible frame flange or retaining channel thickness
코어 밀도	Approximately 450-750 kg/m³ for cellular EPDM or 1100-1250 kg/m³ for compact EPDM
열전도도 (Thermal Conductivity)	Approximately 0.06-0.25 W/(m·K), depending on cellular or compact construction
표면 마무리	Smooth or fine-textured matte black extruded rubber with defined sealing ribs
접합 유형	Continuous cut length, bonded splice or vulcanized rectangular closed loop
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Hollow or cellular profileSelf-adhesive mounting stripVulcanized closed loopCustom cross-section and corner radius

Planning a EPDM Gasket specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.